| Subject | Text |
| KEF PSW-2500 | My kef psw 2500 has just stopped working to. I have had to replace the rectifier and a BD140 transi |
| If memory serves, max. voltage for most three-terminal regulators is 35 volts (7805 min. voltage = 7 |
|
|
| Looking for a schematic for Kenwood KAC-8405 Audio Amplifier | So I have a Kenwood KAC-8405 4/3/2 Channel Power Amplifier. I believe by looking at it that it is |
| Toshiba 36A41 TV. | Brightness problem.
On max settings still dark.
Try presets and darker.
Where to look for problem |
| new cisco ruoter for sale | Cisco WS-SUP720-3B $10500
Cisco WS-SUP720 $8900
Cisco WS-SUP720-3BXL $12600
Cisco WS-SUP32-GE-3B |
| STA353 | ok here or read the pdf icmaster.com
have fun
STA353
PNP Silicon Transistor
Descript |
| there is welding solders and there is PCB solder both use the same name. so now buy a pound of 30/60 |
| hi help needed | The VCC1V8 supply is switched ON by a Enable1V8 Logic High signal whose Voh(min) = 2.8V, Vol(max)= 0 |
| PSU problem Infocus 5700 - heat up caps works | Hi all, I have an Infocus Screenplay 5700 projector with a PSU problem. It fails to startup unless I |
| sharpservicemode | Why Do I Have K123 Text On My Tv Screen And Can Not Control The Audio Volume?
I bout my Sharp LC-22 |
| [color=red:ae444898fb]Special offer:[/color:ae444898fb]
This DVI to HDMI cable is designed to insur |
| 5V to 3.3V micropower voltage regulator | hello,
For a microcontroller programmer using USB port ineeded to convert 5v to 3.3V,initially one |
| If that so, check the voltage between Collector to emitter voltage, from datasheet of 2SB1548A the m |
| 27 inch Zenith with dark picture | I have a 27 inch Zenith, tube, that's about 7 or 8 years old, several years it wasn't used. Anyways |
| You can get the Ricoh Aficio MP 2500 service manual at http://service-manuals-schematics.com
http |
| JVC AV-27020 brightness | 27" JVC was zapped by lightning a couple years back, got it fixed by a TV repair shop, but lost the |
| Diode Replacement? | I saw a few posts ago (early 2009) a member posted something about replacing the diodes in the recei |
|
|
| sansui 500A | howard6606.....
Thank you very much for the schematics of the tube receiver.
Any change of havin |
| Re: Philips K40 26CS5770 system4-dark-low bright pict at sca | [quote:3b2681bf76="ny name Eric fuck you"]Is that TV about 30 years old?
[/quote:3b2681bf76]
W |
| sony str de 475 bad tuner | Hi guys;long time no see ; i need your help,
i have here a STR DE 475 sony receiver and it runs go |
| Toshiba 36A41 Bad gun in tube Or could it be the driver? | Hi I have a Toshiba 36A41 that started to make a loud poping noise in the tube. It also displayed a |
| Yamaha RX-V350 | Hi all,
I recently bought a cheap Yamaha RX-V350 surround receiver that was sold as defective. Acco |
| ivtec | My friends i went shopping for a printer and got one very cheap at Walmart, i got a Lexmark Z2300 a |
| how menny bulbs u have on the sercet, 110v * 7A = 770w peek pover
the lights u are using are more t |
| Re: Philips K40 26CS5770 system4-dark-low bright pict at sca | Is that TV about 30 years old?
[quote:af8cb1bcaa="mauriceh"]I have a little problem with my tv.
|
| MDX-M690 | Dont know if this helps, im sure you've probably sorted it out by now.
Looking at the PDF, the Am |
| need stepdown from 50v dc OCv to below 25vdc | I am upset, I ordered a solar panel and was sent a COMEPLETELY wrong panel from what i ordered, and |
| How on earth do I set this up? | Hi,
I have just come into possession of the following –
Sony SA-W305 and a set of 5 Sony speaker |
| FOUND: Executech, DigiTech, HoTelephone, Americom manuals | Looks like I posted this in the wrong place first, moderator, please ignore or remove from ther othe |
| Re: Just fixed my first photocopier | Clean the fixdrum whit oil...
[quote:68afd613d1="absorbentgnome"]Got a Sharp SF-7300 out of a |