| Subject | Text |
| NEC PX-42VM2G Standby issue | I have just acquired a NEC Plamsa Monitor that has recently developed the fault of returning to Stan |
| Thanks for the feedback. the chemical fuses that you refer to what do they look like? Resistors with |
|
|
| In general, the controls on the pickup has no bearing on your symptoms.
99 percent of the time th |
| leoptics 15c (Picture sides bent inwards ) | Picture sides bent inwards
asking for,
brand=computer monitor- leoptics
model= 15c
problem= dea |
| Hitachi vertical wavy lines | Hi,
I have a Hitachi monitor PC-DC1552. I have a problem when I turn on monitor after few minutes |
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| [quote:f99e2aacc4="cattlerepairman"]I have a ViewSonic n2750w with the same symptoms:
- for a while |
| YOU NEED TO ENTER THE SERVICE MODE AND TURN DOWN THE RED DRIVE,OR "RCUT" AS IT IS REFERED |
| Sbeck-Proscan power up - safe mode | I brought it to a friend who knows alittle about TV's. He had about 10 of them in his house. When |
| JVC AV-27D304 | TO ENTER THE SERVICE MENU
Press the [SLEEP TIMER] key and set the SLEEP TIMER
for "0 MIN".
Then p |
| MODEL?????? CHECK FOR DRY JOINTS, ARE CRT HEATERS LIT, DOES PICTURE FADE OUT OR SWITCH OFF, ANY SYMP |
| Problem with Samsung CS761 Chassis SCT55A | The TV switch on but no picture or sound. I assume the deflection circuits work because the OSD work |
| Hi Guys,
I've finally managed to change the parts as suggested, when I tried the telly, there was |
| Panasonic SD-P5073-K | The top half of my screen is not bad, but the bottom has a blue gun bowing
about 1" high on the en |
| Compaq EVO N1020V Display open | I have a small problem with my Evo n1020v tft display. A small
cable at the left bottom of the scre |
| RCA | You don't give a model number but on several RCA/GE models during the 90's they had a problem with s |
| Hitachi 53fdx20b rear projection tv troubleshooting problem | Hitachi 53fdx20b Rear Projection TV had a conversion problem. Symptoms were typical image ghosting. |
|
|
| Need help with ATX Power Supply | I have a problem with my ATX PSUs. Actually the main problem is probably in the motherboard. The com |
| cheaper solution PROTECT FAN message | from another forum
The message PROTECT FAN may indicate that there has been fan failure, but it |
| service manual for CASIO KEYBOARD CTK-601 pls? | My casio keyboard stopped working after it was left ON overnight. The red LED can be ON but there i |
| Hi, mbelec, | Hi, mbelec,
thanks for your reply...
Where would I see this error code ?
On the PC screen I ass |
| Now sometimes you'll have a screeching noise that is a sign of excessive horizontal ripple from a dc |
| Dead Dell 1025HE | I'm attempting to repair a Dell 1025HE 17" monitor (essentially a Nokia 447S) for a friend.
sympt |
| hardon karmon 7 channel amplifier, 1 channel very low ?? | hello im curretnly working on a hardon karmon avr 507 7 channel amplifier,
it all works ok apart |
| It's probably faulty capacitors in the vertical scan. First overview would be to visually locate an |
| Sony KV2150R help please with repairing this set. | The Stand by/timer LED keeps blinking all time, I have changed the full block of power supply from t |
| Zenith question | I have an old style Zenith Sentry 2 console. It's 12 years old.
When the screen is mainly white t |
| I have the exact same symptoms with my 510.
It Worked perfectly for 5 years and now i have to unplu |
| Hi Minnie, i was hoping you would reply as i've rad a lot of your posts here and even thought about |
| Panasonic CQ-C5303n CD MP3 wont start | Hi, when I attach to 12V the source button just become blue for second, and than slightly turns off, |