Subject | Text |
inner workings of the digital photo keyring | Hi, i'm new to the forum and have been trawling through the raft of info : )
i run a small blog o |
klipsch Promedia 5.1 schematics | I have read all the forums on Klipsch and other related sites. I found quite a few burnt components |
|
| Hi Matt,
Had a really busy weekend and lost your thread in the pile of other threads!
From what yo |
| Common problem with Sonys is the IF module, small metal box usually close to the tuner. Check solder |
Philips FL2.16 | Hello!
I need electric parts list for this chassis. Some components in power supply (smd) can't d |
| Which transistor blew? Was it a main output transistor or smaller one in the pre-amp stages? Why did |
F/SELL BRAND NEW Panasonic 42" Wide Screen Plasma TV $6 | EGOLD ELECTRONICS PLC / BEST ELECTRONICS
COMPANY.
|
| sony tvs suffer from dry joints and they usually hide inside the metal canned units .but from what y |
Sony | Bad solder joints are a common problem with Sony TVs. Look for cracked joints around any heat produc |
please help! need ONKYO owner's manuals and/or advice... | hello, i just purchased a very nice onkyo system for $50 but couldn't get the manuals..( yes $50!!! |
SAMSUNG TV MODEL CB5012Z | I NEED:- SAMSUNG TV CB5012Z
1) TV SPECIFICATION
2) LISTS AND TYPES OF COMPONENTS
3) ISOMETRIC DRA |
| Looked at the blue ceramic caps -- only saw two small ones; but, they look ok. Will need to get und |
power supply question | Hi
when you say primary of the power supply, what specifically?
Is this a switching or linear |
STR-DE598 no display from using wrong speaker (dead) | hi , new to the forum but hope som1 can help , got this str-de598 from a friend who clams to have pl |
| Speakers and wiring are good. The distortion is there regardless of input - whether internal (tuner) |
| [quote:9178dc8f71="wwiiflyer"]Looked at the blue ceramic caps -- only saw two small ones; but, they |
| There is a useful general purpose timer chip called a '555' - you can use a microswitch (ask a sales |
|
TV SET REPAIRS | :D If you are in any doubt as to your ability to undertake any tv repair-dont!!!
There are certain |
Please Help Harmon Kardon surround amp power problem | Hi
Please help i have a harmon kardon AVR630 surround amp. Ive had the unit for about 12 months a |
TECHMAN | PLEASE, I NEED MANUAL SERVICE FOR TOSHIBA E-STUDIO 520/600/720/850 |
Oscilloscope | Thanks vtech,
I will follow your suggestions.
I'm pretty sure it will get sorted.
BTW, I found th |
panasonic tx-25md1 | Hi
With regards to the lines at the top of the screen if they are really faint and only seen in dar |
N2751w | I have an old Viewsonic N2751w with the FSP212-3F01 power supply. Recently, the TV died. There are |
| The power supply is probably bad and it makes 3 attempts at power up and goes into safe mode to prev |
about your tv/vcr... | by this time you probably junked it or got it fixed but im looking for schematics for mine and saw t |
| Start with a good visual examination of wiring, check boards (especially area around the audio circu |
need help | Hi
Dir need circuit diágram. power supply complete blown out can not read components , please |
Sharp TV clicking. | Sounds like a SMPS (Switched Mode Power Supply) fault. The problem with these power supplies is that |
| Thanks for reply, adamij.
Will check these components when I get home! |
IBM G40 Monitor - Not working, - SERVICE MANUAL | [EMAIL me also at: [email protected] , I MAY not visit here again ;-< ]
My IBM G40 15 |