| Subject | Text |
| Re: yamaha RX-V1800 | [quote:e5feb97d31="[email protected]"]I just had my RX-V1800's dsp assembly changed as what the yam |
| Re: Dell Lattitude C600 - Wild cursor | [quote:2cca941a6a="jimenvais"]The cursor on my Dell Latitude C600 usually behaves at first, using ei |
|
|
| The high voltage dropped by more than 20%?
The Screen/Focus assembly went bad?
The set is showing |
| Re: Hi need help with VDO radio | [quote:c74899b022="Liber83"]Hi need code to Siemens VDO CDR 500 (E)
330886636
No.: 93 171 870
|
| Re: 42" digistar plasma screen | [quote:0786074833="rushman"]I have a digistar model 4210D, it takes 5 0r 10 minutes for the screen
|
| Wiring diagram for Mitsubishi TFW 9105 SKT monitor | Can anyone help with the above monitor???
It's something to do with the power supply but need the |
| Sony KP53S25 | It was a neon lamp instead of a cap. I figured out it was going into protect mode, the fault was ma |
| 30 screws! Thought you were a tech.
In order to get to the other end of the cable, you would need t |
| Magnavox 50MF231D intermittent power | Think I have similar issue? Unit powers up, green led's stay lit in back of IR sensor and center of |
| DVD player won't play CD's | Hello, I have a Marantz DV-9500 DVD player and it plays everything fine but CD's. I have changed the |
| Sears LXI Projection TV with no picture | This is a 60" CRT rear projection TV that powers on but with no picture. There are no menus or |
| HP Laserjet 5L: Need Schematic or Service Manual | :oops: If anyone is having HP Laserjet 5L power board schematic or the service manual, please send t |
| Samsung VP-K60 Camcorder | I have a Samsung VP-K60 camcorder, which I am trying to get repaired, Samsung do not recognise this |
| GoodmansGTV 69W | Thanks for replying atom, yeah apparently goodmans "supply" a range of TV's, I've had a look around |
| CD READING PROBLEM | The other gent meant the laser assembly or the motor that spins the disk as being under suspision.
|
| PS, if you are wondering how I was able to buy the assembly seperately.
It was from these guys here |
| Thank you vtech for a thoughtful, if discouraging reply.
I screwed down the player unit and attac |
|
|
| need help | Hi
Dir need circuit diágram. power supply complete blown out can not read components , please |
| Service Manual for PC monitor Fujitsu FPC-CRTAAD | Hello to everybody out here in this forum,
l would like to seek help with the above.
l have thi |
| 50" zenith tv convergance issue | I have a 50" zenith television that i just replaced the hv splitter and focus block on. Originally, |
| Re: Goldstar Breadmaker | [quote:b57b9eb00b="swiddle"]gear assembly underneath the bottom of the baking pan has worn. I will |
| okidata c5100 feeder unit disassembly | I started to print out a couple of laser cd labels before I remembered I had only 1 sheet of cd labe |
| Hi!
Maxo try Service Mode.
Press and hold buttons VOL- and PR+ on the
local keyboard and then sw |
| Zenith | The most likely cause is that the horizontal output transistor has shorted and blown the power fuse. |
| Re: Samsung VP-K60 Camcorder | [quote:f93768f5ca="Andyh_1"]I have a Samsung VP-K60 camcorder, which I am trying to get repaired, Sa |
| Having worked on many pioneers, am very familiar with your unit; Reason is rejecting, coz it's not a |
| Time for a new unit. Laser assembly out ways cost of a new CD/VCR. |
| Hitachi 50v500 color blotches on screen. | You mean the lamp assembly unit that is in the bottom left corner of the TV. |
| Looking for DVD761 (or DVD763) Philips service manual | Hello,
the power board of my Philips DVD761 is out. I need the schematic diagram to repair it.
|
| Nordmende Spectra_V_1404_SV | The VCR does not switch on.
The VCR does a 'tick tick' every second from the power supply. The swit |