| Subject | Text |
| Philips TV orange LED is flashing | I have a 28PW9623 it was working when I left it, I came back inot the room and there was no picture |
| Sony pix flashing | Hello,Neither of you posted model number or chassis so you're not a technician, which I am.The answe |
|
|
| Spectroniq PLTV-3250 wont start | Hello
I am working with a spectroniq (proton) model PLTV-3250
LCD TV. The set will not start I fo |
| Hello Latino,
Thanks for the reply. Unfortunately, nobody here was able to help me locate a serv |
| Electrical Feedback | What are these "amps" you are throwing up as being measured by the cable company? AS expressed, none |
| akai tv CT-T21NM2A | hi everybody!
i need help... i have akai tv model CT-T21NM2A and is on standby mode, anybody enco |
| Proscan service manual | I work at ACE TV in Las Vegas,NV I need the signal board secondary power supply schematic. Voltage t |
| 120V adapter | Wow you went for a nice burn-out when you connected a 120 Volt adapter to the 220 Volt supply.
Wh |
| Regulators in parallel? | I well belive you are being driven MAD!
Simply put, it's WRONG, there is no way that two 7805 type |
| [quote:8046c12511="Anonymous"]Have you checked the horizontal output transistor for shorts?[/quote:8 |
| Beko 22.1 | I have a beko 22.1 chassis where 12V source (LD1086V) is running very hot. LD1086V is turning hot ve |
| Re: Electronics parts for TV VCR AUDIO closing down | I would be interested in all of your CD mech's and parts. Test cd's also. Please let me know what yo |
| Please help, advice needed | Could someone please help me? three days ago my RCA 52' model#p52812bl went out and started making a |
| Which transistor blew? Was it a main output transistor or smaller one in the pre-amp stages? Why did |
| First, what is a LOPT? ” Totally dead with just the high pitched noise.” Horizontal out put transist |
| Yes, have test equipment.
It's old relatives TV. Just wondered if there is a common fault with t |
| Sanyo 35" TV | This is the second Sanyo model DS35520 I've owned. First one, had for a month, wouldn't turn on aga |
|
|
| Thanks for the warning mark.
You are correct that this did lead me to a good path...perhaps the l |
| Test equipment locator | I am looking for a catalog of electronic test equipment which is best source for it, can anyone help |
| What you want to make sure is the ability of the solar panel to provide enough current. Of course yo |
| ESR is rather complex & dependent on several different factors (ie voltage, operating freq, cons |
| Hi Dan,
Those zener diodes are on the BATT_SIG (D401 on BT-006 BOARD) terminal on the BATT/STROBE |
| Pins connector car audio FORD 2004 | HI,
Please, my need design for Pins connector car-Audio
FORD 2004
sn:C486690
Best regards. |
| panasonic with px1 chasis | can u help me with my board with B+ 41V and on and off relay
no oscillation on HV? |
| AVR7000 HK surround problems | Hello all,
I am loate to bring back a zombie thread, but well my amp turned into a zombie so I figu |
| Found my fix | Just wanted to repost what I found to fix my sony kp41s25 dead set.
Everytime I powered up the se |
| no power to hdtv | hi. this is my first post. i hope someone can help. i have a 2 year old samsung hdtv. model tx-3096w |
| You'd probably get a better response if you gave us a little clue!
Does the unit work at all or i |
| sony str de 475 bad tuner | Hi guys;long time no see ; i need your help,
i have here a STR DE 475 sony receiver and it runs go |
| Sanyo | Hi! I Hope you can help me
I just found a Sanyo CEP1497E on the street, it looks ok BUT it dosn' |