| Subject | Text |
| D607 and D608 | Just throwing this out there for anyone wanting some light shed on this F889 debacle. Only I cause t |
| Effect "cushion" Toshiba TP55D80 chassis TAC 9494 | Effect "cushion" Toshiba chassis tac9494. Hello colleagues, I have a TV Toshiba TP55D80, the chass |
|
|
| 8255 is rather old, but it is cheap and has 3 x 8 I/O ports.
There is a lot written about this IC.
|
| Re: Orion Studio 710 | Hello
Need schematic for TV Orion Studio 710.
Only horizontal line… I replace V out TDA8174W with |
| Replaced all transistors | My transistors have finally arrived i've replaced all 4 and 2 further resistors that were connected |
| panasonic tx25 | I would advise taking the set to a Panasonic dealer to confirm this and obtain an estimate as they a |
| Panasonic RX-C45 AM/FM/Casette Boom Box Repair | I managed to get a service manual from an on-line vendor for less than $10. There were problems with |
| Thanks for the feedback. the chemical fuses that you refer to what do they look like? Resistors with |
| Sharp CA1 chas (37et-35s and a 37dm-23s) | My problem is, that from both TV's the scart is not working.
Sometimes its SNOW and sometimes its b |
| Re: philips 29PT5515/01 random switch to EXT1 | [quote:27ac07e204="Arinemot"]a noise signal is getting through EXT1, making the tv to automatically |
| 1) Resolder all the output transistors solder joints and any other intermediate transistor stages th |
| Electrical Feedback going to cablevision connection! | How can this be corrected?
What is causing this problem?
The cable company was just out and the am |
| sony ccd-trv66 | Hi, I'm new to this forum so bear with me please. I have a sony ccd-trv66 camcorder that's been act |
| 5V to 3.3V micropower voltage regulator | hello,
For a microcontroller programmer using USB port ineeded to convert 5v to 3.3V,initially one |
| Now the USB Port Has Stopped Working! | My investigations lead me to trying the WAC3500 with either or both of its drives (DVD-Rom; hard) un |
| Big thanks to those who have replied...
I'm sure that the TV has not been dropped - it had not be |
| thanks but theres no speakers connected when this happens. |
|
|
| I want to have all the parts on hand that are most likely the culprit. I'm trying to gather what I w |
| Help me use a zener diode | I am attempting to understand how a zener diode would work in the following application:
This is |
| Hp L1702 Monitor | Posted: Sat Dec 13, 2003 9:22 pm Post subject: Hp L1702 Monitor
--------------------------- |
| Mitsubishi 50” Projection Monitor | I have a Mitsubishi 50” Projection Monitor model 50P-GHS91 8100026 which is a 1998 model (AC100-120V |
| sony TV Set KV-FX29 21B Schematic | hi,
i dissassembled my sony TV Set to
clean it and replace some exploded capacitors.
i forgot |
| philips 29PT5515/01 random switch to EXT1 | a noise signal is getting through EXT1, making the tv to automatically switch to that channel, back |
| Busted Sensor - Misconnectecd. | I have a sensor circuit that was misconnected (DC was connected to output signals.. :( ), I have che |
| i have repaired the both tv's
It cost some of my time but i have reconnect all of the components.
|
| Service Manual for the Grundig Aura Radio/CD - seat leon?? | :oops: Please can somebody help me, for a service manual for de Grundig/Seat Aura CD. This type a ra |
| LC 4341 | 1/ check DC value (+295V DC aprx.) on the PowerSupplyBoard unit -output DC power for ballast unit
2 |
| Re: Matsui TVR2095TT - resistor value | [quote:54033cd89e="Dickgodden"]Can anybody help me with this please: Resistor R447 connected to pin |
| VGA D-SUB 15-pin connector pinout:
1)Red video
2)Green video
3)Blue video
4)Monitor ID bit 2
|
| ah! thanks, that seems to have made all the difference. The humming stopped once i connected the ear |