| Subject | Text |
| Sounds like fluid damage. The coolant leaks out of the picture tubes and drips on the boards. |
| Help with unlock Nissan Juke | Hi,
please help me with unlocking nissan juke BOSCH:
Part no.: 7 612 033 119
Production date: 1 |
|
|
| how to disassemble RM-887 | Hello service gurus,
I would like to ask a simple question. Hopefully this will be a very easy on |
| Casio ctk -1000 key repair | I have a Casio CTK-1000 keyboard and two of the keys have been pulled up and out of the guide it is |
| Well I finally was able to do the repair on this set. I ordered the wrong caps at first. I ordered t |
| I think I've found something out of place... Clear Fluid!
Or what looks like water, dripping fro |
| Fluid is from one of the picture tubes leaking. (Common on this model.) All you can do is damage con |
| Often when the power connector breaks away form the motherboard on laptops, it is almost an impossib |
| Mag LCD | Ive got the screen and panel for this tv. The problem is to ship the screen you have to ship the who |
| Dear Advisers,
Thanks for your solution to solve my TV Philips 29PT2460/94S problem by replacing |
| thanks for you guys quick responds! ( cogil & minnie )
minnie, how do I check the fluid leaka |
| Take the front of the set off and look for fluid leakage probably from the red tube. |
| Look for fluid on any of the boards from the picture tubes. |
| :roll: dvd player has 2 gain control / separate trimmer for VCD and DVD .,remove disk , close the tr |
| i did that too.
my lcd panel itself is broken. i asked on the forums full of electronics guys on ru |
| [quote:37a149bd9c="Anonymous"]minnie .... I hope your still here !!
Looks like I have to replace |
| CD READING PROBLEM | The other gent meant the laser assembly or the motor that spins the disk as being under suspision.
|
|
|
| [quote:c6ead96b7d="minnie"]He probably didn't get a good seal on the blue crt when he changed the fl |
| Swap focus/screen leads on the block to see if it's the block. Swap green and blue. Who changed the |
| Relay Issue | The Image does not show much except some IC's. However if the relay is activated by a transistor th |
| face | sometimes the solder connections break loose on these faces. the knobs on the volume control and jo |
| To avoid the burning up and oxidising of the tungsten filament in air.
Try to break the glass bul |
| Probably convergence IC's or look for fluid leakage on the boards. |
| Technika LCD40-920 power board problem | Hello
Can someone please look at the pictures below and let me know what the component is that has |
| Yes. You have fluid probably all over the other boards. Time to bail on this one. |
| If it's the flyback your talking about there should be a thick wire and a thinner wire. Scoot the bo |
| [quote:e046e3338e="jts1957"]25 years old
$20 article
How "complex" can it be?[/quote:e |
| Ever hear of 'disposable'? Use 'em until they break (or are connected/used improperly).
20 per ca |
| phillips circuit boards...... | I was wondering how much (ballpark) a new circuit board would run me for a Phillips 60' rear project |
| Philips Ptv 855 model:60p927 | Hi Guys this is my first post here goes
I have projection tv philips 60 Chassis ptv 855. I change |