| Subject | Text |
| Hi Mark thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. |
| STA353 | ok here or read the pdf icmaster.com
have fun
STA353
PNP Silicon Transistor
Descript |
|
|
| Here's some example how to use the LM1086 with a regulated (in your case 3.3 V) output voltage:
[ |
| Transformers rarely break down it self.
Most of the time, it's the electronics supplying and cont |
| AVR 500 Service Manual | I found it here
http://manuals.harman.com/hk/Service%20Manual/avr500%20sm.pdf
Mark |
| PHILIPS MC 165 | HI, I'm looking for the servicemanual for the PHILIPS MC165.
Thanks,
Mark |
| Is the backlight working?
(If not, there could be a problem with the inverter-board.)
Do you hav |
| Do you still have high voltage on the tube? (static sound when turning on/off the screen)
And are |
| :?
hey Kendernauta
Winrar needs part 3!!!!!
please re-post - or do you know why it fail |
| re; repair | Hi, you need to call a tech, Mark is right about the shorted cap in the
HV circuit, you also need a |
| [quote:92340f53da="Al_Dodge_Bundy"]Looks very nice, I'll try to get there sometimes in the future.
|
| 1st item) Because you don't seem to have any high voltage, I'll would start by checking the HOT (lar |
| Hi Mark,
Thanks for your advice. I checked all the power resistors for the value and replaced the |
| Pfff, Guess the picture, that's harder then I expected :D
Isn't this the spring that pushes the |
| Hi,
Great camera! I've go one my self!
Had the same problem also!
Some contact below the ba |
| Indeed sounds like a failing belt or pinch roller.
You can buy service kits for most vcr's and mo |
| Start by checking the largest transitors near the flyback trafo (called HOT, used for H-deflection a |
|
|
| Mark you're on the right track. Try replacing your convergence ic’s. Don't forget to check the bias |
| Hi have a look at this link download/open the pdf file here-:
http://www.s-manuals.com/smd/bc
I |
| Just use a switch with 2 seperate contacts.
e.g. a switch wich 2 * on-off-on connections.
e.g. |
| There are two causes for this failure:
1) Faulty tube, but most of the times two colors won't dis |
| Great tip, Chris.
Grtz Mark |
| sony kv28wt72 engliah manual needed | Hi!
I badly need a sony kv28wt72 manual my cable does not get all the channels
PROBLEM: my tv |
| Please check if there is a short in the high voltage circuit on the main pcb.
(probably a shorted h |
| Ohh, I don't think I can help you with which pin's are connected to what parts. You could try to sea |
| Denon PMA 250 help please | Newbie so apologies if a make a faux pas - I'm looking for service onfo for my Denon PMA 250 Mark II |
| Thanks for the warning mark.
You are correct that this did lead me to a good path...perhaps the l |
| Old TV's have often bad solder joints.
Try to gently tap on some components (special the flyback |
| Hi Mark thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. |
| Hmmm. This could be a pain in the arse, but maybe not. It is possible that there is a missing low vo |