| Subject | Text |
| Pfff, Guess the picture, that's harder then I expected :D
Isn't this the spring that pushes the |
| Hi,
Great camera! I've go one my self!
Had the same problem also!
Some contact below the ba |
|
|
| Indeed sounds like a failing belt or pinch roller.
You can buy service kits for most vcr's and mo |
| Start by checking the largest transitors near the flyback trafo (called HOT, used for H-deflection a |
| Mark you're on the right track. Try replacing your convergence ic’s. Don't forget to check the bias |
| Hi have a look at this link download/open the pdf file here-:
http://www.s-manuals.com/smd/bc
I |
| Just use a switch with 2 seperate contacts.
e.g. a switch wich 2 * on-off-on connections.
e.g. |
| There are two causes for this failure:
1) Faulty tube, but most of the times two colors won't dis |
| Great tip, Chris.
Grtz Mark |
| sony kv28wt72 engliah manual needed | Hi!
I badly need a sony kv28wt72 manual my cable does not get all the channels
PROBLEM: my tv |
| Please check if there is a short in the high voltage circuit on the main pcb.
(probably a shorted h |
| Ohh, I don't think I can help you with which pin's are connected to what parts. You could try to sea |
| Thanks for the warning mark.
You are correct that this did lead me to a good path...perhaps the l |
| Old TV's have often bad solder joints.
Try to gently tap on some components (special the flyback |
| Hi Mark thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. |
| Hmmm. This could be a pain in the arse, but maybe not. It is possible that there is a missing low vo |
| There could be two failures:
1) There is a secondary short. (most of the times the PSU will make |
|
|
| Try to check the diode-bridge and main-switching-transitor/fet in the primary side of the power supp |
| The datasheet for your component is here:
http://www.alldatasheet.co.kr/datasheet-pdf/pdf_kor/TOS |
| Water and electronics don't go well to much... :(
After you let the unit dry, you can to try to |
| Can you check if the power supply is working correctly?
E.g. do you have +B on the HOT transitor? |
| philips 32pw6515 stuck in standby? | hi my philips tv (32pw6515) is now stuck in standby (red led on) and no responce from either the on- |
| Couple of quick checks... | First I would physically look into the picture guns. Powered down of course. You are looking for a m |
| Could you check if there is any voltage e.g. on the collector of the high voltage transistor?
A b |
| dear mark, thanks for the help, so
1st Item. I am not seeing any difference, but when power is |
| Just resolder a new connector to the low voltage wire.
Using some different sizes heat shrink tub |
| Beko NR26114R TV User manual | Hi there, can anyone please tell me where I can get a user manual for this tv, or how I can tune the |
| Are you still able to put the TV in stand-by mode (with the remote controll)?
(and does the flash |
| Duh? I'll gues so, what's the point of selling them in the first place :D
But I think you meant |
| Most TV failures are not regional related, so I would gues you'could drop any questions here, if you |