| Subject | Text |
| Radio code Renault Scenic II | Hello
I"have Scenic II radio its not works, please radio code
RENRDW132-10
RNRD045018 |
| I don't habve any specific IC to recommend.
But check out
http://www.electronics.ca/reports/mu |
|
|
| thanks for all the help.---can you tell me what that grey and black connector that plugs into the po |
| replace the convergence ics. |
| maybe i am getting hosed? | Hi Larry -
They would charge me $369.50 for labor, and $80,00 for parts.
It was an in-home visit |
| Re: stk392-020 and stk392-040 | [quote:fdb252ee69="espbaum"]hi, I know an stk392-040 will replace an stk392-020 but is it just an up |
| replace 2 convergence ics on d board and check 6 pico fuses.they are mounted on heat sincs near rear |
| Vertical output IC's should never be designed so critically that the heat sink compound is a factor |
| sony kp-53s25 | I'm working on a KP53S15 right now. It does the exact same thing. But the thing is if I disconnect |
| Start by replacing the two STK392-110 IC's on the power board and also check all the resistors aroun |
| Ok that you have already ordered it but I thought you were going to do some measurements first. STK |
| Sterio Aiwa keep in security mode | hello all,i have a Sterio Aiwa model NSX-SZ35,first time it start normaly and works for minute ,th |
| Zenith | JD, you either have blown STK`s (convergence IC`s) or R3243 is
bad, you don`t give enough info to l |
| Thanks for the warning mark.
I did put a load on each of the pins to make sure that it resonates |
| Check the pico fuses that feed the convergence IC's. |
| aiwa mx-d8e ic 760 | i, i have a problem on an audio amplifier it´s a aiwa mx-d8e and i dont know the reference of |
| OPTIMUS ST AV-3260 RECEIVER ON - OFF PROBLEM | I GET SAME PROBLEM WITH ONE DISCARD FORM OTHER TECHNICIAN/ MINE HAVE ALSO OK THE RELAY/ ETC/ MINE SO |
|
|
| [quote:c689a7826b="vtech"]When it comes to blown audio output circuit, there are no safe bets in any |
| WTB Zenith DVD5201 | i am looking to buy a zenith dvd changer model 5201. need not power up as i am after several oem ic' |
| I have the same problem, but there is no burnet components, i tested the regulator there is somethin |
| Re: Code for PHILIPS CCRT700 needed | [quote:725d10d456="TomekWGM"]hello
unfortunely there's no way to found a code in a car documentatio |
| philips | hello
i have a philips model FW-C550/37 mini hifi system
the system powers up and everything but |
| Sharp SA200h | I have a Sharp Sa200h with an amplifier TSK463 and when the volume is increasing distortion in a col |
| I am looking for MC 2833 - SMD version | I need 10 pcs.If someone has them - please, leave a message here MC 2833D are Motorola ICs. |
| [b]SONY TV MDL# KV-27HFR Trinitron - No Picture after 45 Sec | [b:3b1fed15b4]Dear Admin,[/b:3b1fed15b4]
A bundle of thanks for such a wonderful Forum, I appreci |
| so it could be the control IC, can u give me some ideas about that IC's function & it's cause's |
| RZ2500amp | I've repaired a RZ2900 with the same problem, I replaced the output I.C STK 4152II and replaced a ze |
| So much for the tech, took the board out and checked the chips and he missed out solding about 6 of |
| Re: TY ITT Nokia 7171 digivision | [quote:105b4dbf12="gavrilo"]Hello,
I have a TV ITT NOKIA DIGIVISION 7171. There is no color on t |
| do you think they could have burned up when the hv splitter failed?? i am just thinking it is weird |