| Subject | Text |
| there is welding solders and there is PCB solder both use the same name. so now buy a pound of 30/60 |
| hi help needed | The VCC1V8 supply is switched ON by a Enable1V8 Logic High signal whose Voh(min) = 2.8V, Vol(max)= 0 |
|
|
| [quote:eacd3436c9="Anonymous"]hi,i don't know if this information is of any use as i am new to forum |
| after loading the disc give the disc a quick spin with your finger before display says no disc, if s |
| PSU problem Infocus 5700 - heat up caps works | Hi all, I have an Infocus Screenplay 5700 projector with a PSU problem. It fails to startup unless I |
| sharpservicemode | Why Do I Have K123 Text On My Tv Screen And Can Not Control The Audio Volume?
I bout my Sharp LC-22 |
| [color=red:ae444898fb]Special offer:[/color:ae444898fb]
This DVI to HDMI cable is designed to insur |
| I was hoping it was worth a shot. I once saw an electronic shop that upgrades Pioneer laser disc pla |
| Need Teco TV Manual | just a shot in the dark, can't find this anywhere
TECO TV Model: TL3011FM
thanks |
| LG rt-42px10 42" PLASMA TV | Hey,
LG 42" plasma tv Rt-42px10
So the tv turns on (green light) but fails to produce audio |
| 5V to 3.3V micropower voltage regulator | hello,
For a microcontroller programmer using USB port ineeded to convert 5v to 3.3V,initially one |
| If that so, check the voltage between Collector to emitter voltage, from datasheet of 2SB1548A the m |
| 27 inch Zenith with dark picture | I have a 27 inch Zenith, tube, that's about 7 or 8 years old, several years it wasn't used. Anyways |
| cool voivo .... and here some error codes from me ...
Sony HVR-Z1U and HDR-FX1 Error code 61:10 b |
| 12 yr. old 36" Sony TV | Hi Forum:
I have an old 36" high end Sony TV (PIP, on-screen snap shot of every channel), all |
| JVC AV-27020 brightness | 27" JVC was zapped by lightning a couple years back, got it fixed by a TV repair shop, but lost the |
| Diode Replacement? | I saw a few posts ago (early 2009) a member posted something about replacing the diodes in the recei |
|
|
| sansui 500A | howard6606.....
Thank you very much for the schematics of the tube receiver.
Any change of havin |
| Sony subwoofer | Hi - hate to say it, but it looks like this needs more than a fuse. ANYtime a fuse pop insantly, th |
| PASSWORD REMOVEL | HI FRIENDS,
I NEED TO REMOVE PASSWORD FROM DELL 510 INSPIRON I ALREADY SHOT BATTARY BIT STILL NOT G |
| Re: Kenwood KAC-7201 | [quote:a0b60ec7b2="Xaser"]Hey,
I just bought this amp to find that capacitor C231 exploded, I was w |
| sony str de 475 bad tuner | Hi guys;long time no see ; i need your help,
i have here a STR DE 475 sony receiver and it runs go |
| Toshiba 36A41 Bad gun in tube Or could it be the driver? | Hi I have a Toshiba 36A41 that started to make a loud poping noise in the tube. It also displayed a |
| Yamaha RX-V350 | Hi all,
I recently bought a cheap Yamaha RX-V350 surround receiver that was sold as defective. Acco |
| power supply board | The 606 diode (heatsinked, to-220 case) has been shot. Replace the blow caps and the 606 chip. Mak |
| IC's were bad | The pico fuses were good and there were no leaks, but the IC's on the middle board behind the large |
| DSC-F707 | Hi,
My Sony DSC-F707 has gone really weird. . . .Sometimes will not power on, fives me an infolit |
| how menny bulbs u have on the sercet, 110v * 7A = 770w peek pover
the lights u are using are more t |
| Re: Philips K40 26CS5770 system4-dark-low bright pict at sca | Is that TV about 30 years old?
[quote:af8cb1bcaa="mauriceh"]I have a little problem with my tv.
|
| Kinda thinkin' perhaps buy a very similar model thats also faulty (found one) on ebay and replace wi |