| Subject | Text |
| Re: Protect LED | Set is now dead again as I suspected it would be (almost made it to XMAS :x), anyone have any clues |
| replay | Olá amigo Gringo... os fios que estão sobrando devem ser ligados na parte da fonte de alim |
|
|
| si si | si soy de almeria el caso es que lo conecto y va bien pero al minuto me sale en la pantalla too hot |
| Usually, the same basic design of a PC power supply is manufactured in several versions with differe |
| Canon IXUS700 repair,where are the fuses? help, heres pics. | Hi there.
I have a 7mp Canon IXUS 700, it was dropped by my brother. So cant be fixed under warra |
| Vertical Lines | species8472, i think this was more luck than judgement. The vertical line is caused by 1 of 2 reason |
| Where can I order this part?! It's a relay... | A relay made by OEG, it's part # SDT-SS-112DM. I just need one, but the sources I've found online on |
| Measure Voltage across C619? (If more than 250 WILL overheat) |
| ok here's the update. had a repair person and his son come out (from a local small tv repair shop i |
| Thanks again for your help and info | Sparky thank you very much for your time and help, just a few more questions if you don't mind: I a |
| A question about fuses | Hi guys,
I'm not exactly electronics savy... I have an international power adapter I use when I t |
| If the information isn't in the service manual, which it isn't, then it isn't available anywhere. HP |
| 450 volts @ 330 micro farid 105 degree temp rating. |
| Re: 60 inch Zenith projection tv starting to blurr out, Fix | [quote:a37d602a74="RJ"]Nine year old 60 inch projecton tv starting to blurr out. Better to fix or g |
| Westinghouse LTV 32 Fuse Problem | My westinghouse ltv, which I use as a computer monitor, stopped working after some sort of power sur |
| Dear Friend, check Video out put transisitor collector volt(i.e 180 volt) emitting from the fly back |
| Dear little Diary | Me, meself and I again :lol:
Lucky I like meself 8)
A little post to say that its back from th |
|
|
| I'm turning one Printer Epson LX-800 into one b-printer | I need to slow down the carriage or all the printer mecanism in order to
use one device that marks |
| osvetlenie | Pekný deň, neviem či som v správnej sekcii, ale pokúsim sa nadefinovať |
| Around here, it would run you about $250 plus tax to get it installed. After it's fixed, find some p |
| Sony KV-36FV27 Blows Fuse | Hello all,
I have a Sony KV-36FV27 that was working perfectly fine. All of a sudden one morning i |
| I'd suspect the light engine. UX22201DR about $250. |
| In this application, (coupling) it is not going to make a difference as 250 MFD has not been a comm |
| ayuda con tv sharp | Hola buenas noches espero que este tipo de ayuda no sea incomodo porque se
que es algo laborioso p |
| Hi,
I also have the Mackie SRM 450 and am trying to replace the R282 and R283 10 Ohm resistors. I' |
| VP322 not working | Hi DigitalScorpion,
Same thing here. TV logo is orange and turns to white. I replaced the bad cap |
| Pip Bypass Success - 930B552 | Woo Hoo :D, I have a working big screen. I took the capacitor values you recommended, and used the d |
| change boot elkos..i think that is 1 or 2,2 mf 450 volts and 47mf 26volts..
regards |
| Thanks | Hi,
Thanks for that info. I searched through the service manual, and there was no listing for those |
| Minnie,
many thanks - chip is on order.
the legs of the R51 resistor look blackened so I guess |