| Subject | Text |
| 75 ohm connector repair | The 75 ohm cable connector broke off the back of the television. Can I fix this myself? If I take th |
| Zener 6079 (9.1V) is shorted. R3045 measures 1.8 ohms.
If anyone else needs to know in the future, |
|
|
| Not even a late-comer? Good god this place is a ghost town.
All the capacitors in the area check |
| Replace the M-board and 330K ohm and 470K ohm resistors at the A-board. (I gues R6018 + R6019, they |
| [quote:20c42c88bc="joshg3p0"]I can test the other transistors for short. I think I did that, but I'l |
| Hello, check the resistor value of the pin 21 and 22 of the flat cable lens.
If this value is to of |
| Re: 50" zenith tv convergance issue | [quote:5df3b9f13b="riverdale"]I have a 50" zenith television that i just replaced the hv splitter an |
| Re: Goodmans GTV42P3 42" Plasma TV - Power Board Repair | [quote:ba34fe886c="Mad Professor"]Good Day All.
I have a 3 year old Goodmans GTV42P3 42" P |
| 50" zenith tv convergance issue | I have a 50" zenith television that i just replaced the hv splitter and focus block on. Originally, |
| Denon DRA-685 Remote Volume | Hello,
I replaced the two 1 Ohm resistors in the +&- 15V lines as Mitch suggested and the &qu |
| Forgot to say R629 should be 2.7ohm for 90 degree crt, 27 ohm for 110 degree crt, |
| Neufunk TV 34BNA Futura,instruction manual | Hello,
I just repaired a Neufunk tv 34BNA ,which had a white screen and flyback lines across the |
| Daewoo DV-K813 VCR video loses time at power cuts (battery) | Hi, I am writing this to help anyone who might have had the same problem as me. I bought a great Dae |
| 90% regulation power solver replacements are as follows:
C4108--39 mfd/100 volts--RCA #208002
C4 |
| Fusible resistors better than Fuse in TV Power Supplies??? | I saw the fusible resistors ( typically 1/2 watt. .1 ohm rating. Sony #1-202-933-61 ) used in a lot |
| [quote:93e26ac61b="vtech"]Depends on your Amplifier drive capability; while it is not too far off, |
| While you may have a calibration issue, I've never seen a problem in measuring resistors in general |
|
|
| Sorry my mistake, it's 3-3.5 ohm from that wire to ground on the amp pcb |
| HT 900 | I am posting again to let you all know of a workaround. The problem here is that the circuit supplyi |
| hitachi projections | These units can be very easy to repair. you need the service manual. see if it is an AP73 or AP74 c |
| PVY4665RK | :roll: Larry, I hate to keep imposing on you, but I have been unable to locate any supplier that sto |
| measuring high value resistor? | i have a 1.8 Mega Ohm resitor, my meter can read up to 2 mega ohm, but when i try and read the value |
| I'm also having this problem. tv shuts of, power light blinking. used to be able to unplug/replug an |
| R609 and R610 are both 68 ohm. Check D601 and D602 for shorts. Both are zener diodes. D601 is a UZ |
| The wife said the picture went a little fuzzy before they shut it off and when my son try to use it |
| potentiometer / rheostat questions | Hello,
I have some 12 volt DC "rope lights" I am putting in my motor home. I am trying |
| Yikes! Now it's getting complicated! I found the Power Transistors and ordered them through
htt |
| Sony subwoofer | Hi - hate to say it, but it looks like this needs more than a fuse. ANYtime a fuse pop insantly, th |
| i had the same setting, try flicking it over. im not convinced its solved my problem yet. but last 2 |
| Pioneer SA-508 | Hi!
I need some help with this amplifier from pioneer. Since I can´t find service manual or |