| Subject | Text |
| i had the same setting, try flicking it over. im not convinced its solved my problem yet. but last 2 |
| the only advice i can give is to check that all the connectors are firmly pushed in check the fuses |
|
|
| Re: Need help identifying components please. | Hi,
A 6600 system a customer has experienced a similar problem.
Q5 - a H945 transistor (2SC945 |
| Old B,
If you take a little time to look at the diagram, you will see that by taking Q101 and (su |
| Hi
Don’t think about the colors (values) of the resistances, be sure.
The resistor 1 is 560 Ohms & |
| Thank you so much for the detailed answer.
I'll have a go at it over the weekend.
I might not ha |
| Re: I dont hear anyhing when i hit the power button. | That is a ceramic time delay type fuse T6.3AH250V which should show about zero ohms if good.
What |
| ok so with the board (43) floating, i measured from each pad on that board to ground. some of the m |
| [quote:78255ff566="gary"]daewoo say sustain panel has to be replaced as an item!!!!!!! also it often |
| Check the resistors by the ic's, should be 2.2 ohms. Under the heat sink. |