| Subject | Text |
| Hi,
I also have the Mackie SRM 450 and am trying to replace the R282 and R283 10 Ohm resistors. I' |
| service mode ? | hello,
Does anyone have the service mode codes for a panasonic pt56tw53g ? |
|
|
| VP322 not working | Hi DigitalScorpion,
Same thing here. TV logo is orange and turns to white. I replaced the bad cap |
| Pip Bypass Success - 930B552 | Woo Hoo :D, I have a working big screen. I took the capacitor values you recommended, and used the d |
| change boot elkos..i think that is 1 or 2,2 mf 450 volts and 47mf 26volts..
regards |
| Thanks | Hi,
Thanks for that info. I searched through the service manual, and there was no listing for those |
| Minnie,
many thanks - chip is on order.
the legs of the R51 resistor look blackened so I guess |
| That is a very old Mitsubishi projection set. The average cost to replace the convergence output IC' |
| AVR-2105 | Yo tengo un problema similar al tuyo con un AVR-2105. Se enciende de forma intermitente en rojo el b |
| Protect LED | My Hitachi 50FX30B had been dead for quite a while, but this weekend I took some time to go over it |
| Have been out of consumer electronics for some time...I used to see this problem on a regular bases |
| I did take it to the only authorised Marantz dealer in my country. After them servicing it and telli |
| is this for same problem.the 2oo volt cap is near the flyback and is rated at least 250 volts.was th |
| tv | i replaced with a 4amp 250 slow burn and it fixed my no power problem. |
| Sony KV 32S35 32' TV | When I power it on I can hear sound but no picture. It did come on once but when the power went out |
| Re: Compaq V500 CHB5337 | Hola Jose Antonio.
Por favor tengo la misma inquietud me podrias indicar si conseguiste el service |
| cdp-cx450 | Hi,
the 450 I have tries to load an empty disc. it goes from slot 1,3,5,7,9
if a disc is in slot 1 |