| Subject | Text |
| [email protected] | Thanks for the input,
I was wondering if you could send me in the ri |
| What seems to be the problem? We are also using same generator and would like to help you towards yo |
|
|
| In order to measure the output of an amp, you would need test equipment;
Load resistors, scope |
| Philips chassis EM2E , dont' start only stand by flashes | Hi guy , have problem with this TV , when press main switch , the red led is present if press remote |
| That depends on which kind of billing pulses is used in the telephone network where the unit is to b |
| Did you swap the digital convergence generator? Or is that on a different board. |
| Help!!!!how to install a 327 chip into a 325i bmw | Hello all, can anyone tell me how to install a 327 chip into a 1986 325i bmw, also wot diff it would |
| Looks like it. Tried looking for VC1031 Datasheet. Apparently it is an ancient, non-existent NEC dri |
| SONY KV29FX20E. LED BLINKING TWICE | hello can you help me with this fail? thanks.
i think that its the fe1a chassis, when try to star |
| Without being able to see more of the equipment, it would have to be a guess based on what is shown |
| LG CN-27A24G | TV marks LG, but it has TRC Philips and chassis ZENITH, the IC STR53041, I need the scheme, beforeha |
| I had the same problem and I solved in this way (cut & paste from nl.hobby.video newsgroup messa |
| Problems with LG plasma tv PDP42V5 using DGK-420W ( DGK420W revA) power supply pcb.
This PSU is al |
| Sharp tv 70DS-03SN, hiccuping PSU | A tv as above has hiccuping power supply. For each pulse, there is a flashover across R820 (1K0 SMD |
| Service manual needed for Fluke/Philips PM5515 PM5515 PM5518 | I needed for the manual of service in pdf of the pattern generator for tv mark Fluke, the model is P |
| Turn yr PC into an O'scope,SpectrumAnalyzer,SignalGenerator? | Wanna turn your PC into an Oscilloscope, Spectrum Analyzer, Signal Generator, and more....without an |
| Need PM 5131 & PM5132 manuals ? | Hello,
If anyone is interested by operating and service manual of Function generator Philips PM5131 |
|
|
| Philips Tv 14PT2666 is a chassis L01.2E.
This file is for you:
http://www.eserviceinfo.com/downl |
| Hi to you all newbee on forum would like some help please | Depends on the use but I would use a pulse width type like the one in the link below as the D.C moto |
| Could be a number of possibilities. The optocoupler pulse is used as a source to counted down /proc |
| :idea: Found the following:
1) C951 = 4.7ufd/250V
2) Suggest changing these caps in standby po |
| no no, if you click on 1st TOSHIBA on that page & scroll down to 21N21.
I'm pretty sure the o |
| What type of signal should I be seeing on the flyback generator (pin 11) located on vertical deflect |
| TDA8174A lowers imput impedance suddenly ? | Hi,
I have a TDA8174A as vertical amplifier. The vertical trigger pulse from the TV processor is in |
| Yes, I believe the speed is controlled by some magnetic wave or something like that.
The connecti |
| Bosch KGU30604GB Freezer compartment too warm | Hi,
I have a Bosch frost free fridge freezer KGU30604gb that used to work fine now the fridge is ok |
| [quote:97eef1088b="Anonymous"]please forum members is there anybody there, Moderator I'm desperate![ |
| FAx Machine ppf 411 | Hi. I have that service manual, but what is your problem with th fax machine? i know very well Phili |
| Panasonic CT-27SL14J | Need Service schematic for this TV. It will not power up, have gone as far as I can without schem |
| [quote:eb6f71e345="PatXaran"]Hi,
I think your post may be dead and buried, but I just discovered it |