| Subject | Text |
| how to check for an open resistor? | how to check for an open resistor? by analog meter |
| Samsung ANION | Hi,
It's a Samsung 731b LCD monitor. I'm trying to figure out the pin layout for the connector from |
|
|
| Could be short circuit at regulator output, try to disconnect power amplifier then turn it on again, |
| convergence | well R3243 the 110K Ohm or 120K Ohm resistor (both values have
been used by Zenith) should be repla |
| sound but no picture | Hello,
If you see a bright horizontal line , horizontal deflection is still working, if heaters glo |
| A mobile phone is similar to a two-way radio in this aspect. Typically, a such radio's receiver need |
| Sony TRV318 Help | I hadn't used tghe camera for a while and when I wanted to use it that is waht happend:
I wanted |
| The notebook display is the sam as the other for desktops.
It will be better if your video adapter |
| SAMSUNG CI533CN | Hi,
Anybody help me with a circuit diagram for this model.
The audio output is working, but |
| measure dc voltage at bad chan. output with no load. if over 0.1vdc then driver amp (circuit prior t |
| Re: Polishing of Silicon wafers | [quote:c090204838="Saurav"]Hi,
I have come across a technological development where we are a |
| There really are so many variables to even attempt to guess at the problem... the guy who gave it to |
| Yamaha RX-V520 Main Speaker not turning on | Hi,
I have a Yamaha RX-V520 A/V receiver which up until recently worked fine. About a month ago o |
| Sounds like a mistake in buying......
While an oscilloscope can be used to monitor video & si |
| [b:73460c2633][url=http://www.opentip.com/products/Samsung_BW_inch_ms_WideScreen_DVI_Height_Adjustab |
| Ok so here is where the dumb questions start....
What are the output IC's?
Where should I be t |
| re; vertical | Hi, you have bad electrolytic caps in the vertical circuit, usually
replacing ALL the defective one |
|
|
| Sony Amp - The woes continue | Andreas,
Try removing every input and output and see what happens, then add them back one by one |
| Plasma's are ment for board level replacement. If it's not working I would start with the power supp |
| Please make sure the vertical signal is sending out from Matrox Millenium by oscilloscope or counter |
| Umm no it's not a HIFI. It's my oscilloscope - http://www.tucker.com/java/jsp/doorway_partnoTEKTDS3 |
| - Check for mecha's assy wear, inclusive tape path guides
(not a good thing to play with the al |
| the best procedure to check ultra fast diode by analogmeter | the best procedure to check ultra fast diode by analogmeter
what is the best procedure?
how t |
| JCV LT32x576 Weird Green Pixelated Screen | I've got a broken HD Tv. It's a JVC 32X576. It's a few years old and one day when turning it on the |
| Ok, now I understand. Unfortunately from what I can see, having an only DV input is rather limited & |
| RF Modulator | Thanks for the help guys (or girls?) - will look at the link suggested by Guest.
But thought of a n |
| STR-DE875 Service Manual is needed (or just a part of it) | Hello folks! ;) i'm new to this forum and i've very pleased with it since it might solve my problem. |
| Thanks for the feedback. the chemical fuses that you refer to what do they look like? Resistors with |
| Philips MT6000 Freevents new XP driver ? | I had trouble finding drivers for XP for my PC Philips MT6000 Freevents.
I found these drivers: htt |
| tektronix 464 service | Hi
I need service manual or schematic for Tektronix464 oscilloscope.
Thank you |