Subject | Text |
| there is a programme called sscserve which is quite good.what can happen if you keep using head clea |
| [quote:37698b6a42="Anonymous"]thanks minnie, but I am not an idiot. I have tried basic troubleshooti |
|
Philips TV 29SX8671/29SX8771 G8A Chassis | Greetings all,
I have a problem with Philips TV. No controls work, no sound, but |
| dont touch any alignment controls they are for factory use only, just replace the pickup, the alignm |
Power supply blowing up | I also have the same model power supply blew up after 2 years. Sony have disowned it. Obviously a ru |
KEF PSW 2500 relay buzz and audio outout buzz | Have just repaired a similar problem with a KEF 2500 - relay was chattering at 50 Hz rate, buzz in s |
Another Vizio VW42L Tv out of the land field for now. | Hi guys; a success repair on Vizio VW42L that someone dumped it on the side of the street it started |
Re: Basic questions about TV | [quote:d3b0cb0b75="Rouslan N."]I am repairing a TV for the first time and have no experience\knowled |
| [quote:7c03f7aab0="jts1957"]Jumpers, especially at locations 010 and 050 - resolder. Check F850, F85 |
| latest on my set is - will never switch on (just the flashing warning mode led) if room temp under 1 |
Re: more info on replacing the parts directly | [quote:d8a829bb09="white squirrel"]I have some help to give if you have the exact same problem.
Wh |
| JTS is correct on troubleshooting. I had a microwave that lost it's display and trouble shot it down |
Re: Compaq V75 Monitor starts then dies after one second | [quote:f5eac50de1="Aladdin"]Hello friends,
I have 3 Compaq V75 monitors that have the same symptoms |
| The pots are potentiometers like the bass, trebble and balance knobs, and any function selector li |
| there is a mechanical focus on the top of the picture tube,loosen wing nut and adjust either way.but |
Is this really the same convergence fault? | I also have a 42H81 projection TV that has the two vertical lines spaced on the thirds. The lines ar |
| Turn your T.V. off. That thin bright line is a full screens worth of brightness in a very small area |
|
| Thanks for the reply!
I do no thave the schematic, and wasn't able to find it on this site. Howev |
| Hi Vtech!
Thank you very much for your the help.
The first thing I've thought to blame was the vol |
Analogue radio repairs | Radios for hard to fix radios
GP300:
Fault…. Doesn't turn On (Dead radio)
1/Check Fuses
2/Resold |
PVY4665RK | :roll: Larry, thank's for the vendor info. I will have no problem removing
and installing parts. Al |
| [quote:2be1234afc="airhead_1"]Good morning - The problems on all of the P30/P35's that I have fixed |
| If you're unsure, don't touch anything. I use plastic precision adjustment tools to access them. |
monitor switching on and off repeatedly | Although I don't have a service manual their is obviously a short.
Measure resistance of collector |
panasonic microwave nn-s262bf | Thanks JTS1957 for your response. The problem I described was in error. Apparently my wife removed t |
| [quote:0535d99e5c="absorbentgnome"]Lol, I remember doing this as well. I'd crank the volume up, lick |
Picture squeezes horizontally | Make and model of set would normally be required for more detailed diagnosis.
With the set unplugge |
Re: Pioneer A 616 Mark2 | Some one have a servicemanual to this one?
Then i raise ore reduce the volume, the protection circu |
| Disconnect the front key pad switches. Then use the remote to try and turn it on. |
| There are in fact cases where flat cables or flexible PCBs are glued in place. Mostly when one of th |