| Subject | Text |
| cable lead for Technics ST-HD50 with a Compact disk Player | Dear all,
I have, in vain, been looking for a cable lead for Technics but could not find one.
|
| I don't habve any specific IC to recommend.
But check out
http://www.electronics.ca/reports/mu |
|
|
| Unusual request. | Greetings All:
Am trying to repair a Bosch AL60 DV2425 Battery Charger. Upon closer inspection th |
| RCA D52W23 ICT222 | My television blinks 3 times and never comes on. I think what I have gleaned by searching on the we |
| I have same tv but after replacing capacitors still no picture on screen. Standby red light comes o |
| Hi G Money..
Are you conected to the correct terminal on the P.C.?? (Preferably "Line Out?")..If |
| NAD 317 service manual or schematics wanted | Any one has a copy or a lead as to where I might find one?
Damn, I'll even pay!
Thanks,
Jef |
| this is a known fault on these sets, resolder ic701 on b3 pcb, do not attempt unless you are comfort |
| Thanks for the warning mark.
You are correct that this did lead me to a good path...perhaps the l |
| Intercom buzz | Lots of faults can cause buzz, but no ground or poor or corroded ground connections on shields is a |
| Circuit dia of SONY KV-J21MN1 21" colour TV. | Please does anyone have the circuit diagram of SONY TV
Model number: [b:39e1f31a82][u:39e1f31a82]K |
| HUGE sigh of relief ! | I was bordering on bummed out, :? hoping there was nothing wrong with my monsters.. I will defi |
| No Sound from Onkyo | This is a signal tracing task. Signal tracing is the most basic trouble shooting technique after si |
| Ok 1st things 1st I may have miss lead you on the last test
those High voltages may have been Mv I |
| Toshiba SD-V291 VCR/DVD combo ejects tape immed after load | Hi. Above noted machine loads tape, but then imediately ejects the tape. I removed the cover and t |
| Maybe you could sell your daughters and buy a big screen? LOL
Sorry:)
I am not familiar with y |
| Step-Up DC-DC Converter from TDA2822M | For circuit Step-Up DC-DC Converter it can make from many method Step-Up DC-DC Converter in this |
|
|
| I agree with Miguel. if your mixer has PAN controls just turn all of them to the same end so your ch |
| I usually just take a magic marker and draw a line across the control - that is across the movable p |
| replace q906 on main pcb with 2sc2001, original transistor is smd and not up to the job, 2sc2001 is |
| jd75125 addendum PVY4665RK | :) Sorry Larry E, I did not provide much info. after taking more detailed
look at TV, here are wha |
| soldering always getting a dull finish, dry ? | hi,
i bought a soldering atation and doing a bit of soldering work on a curcuit board,\
howeve |
| Philips tv 28pw | Hi can anybody help???
I have a philips 28" widescreen tv and all works fine apart from video |
| turning it off and back on clears this up?
sounds like it may be a DCU problem (digital convergence |
| cd changer leads | Hi everyone,
Can anyone help with a wiring schematic for a cd changer lead from a renault scenic |
| Matsui scart problem | Hi,
Can anyone help please. Matsui 1414R tv. When I play a dvd through the scart socket the picture |
| Testing the circuit is to be done with the power off!!
Do not apply power until you are sure you ha |
| I would check the high voltage block, it is common in rca projections that this part goes down....it |
| Problem with STR-DE515 | I had the same problem. Display won't come on at all. I found the 12V relay on the 120VAC input PC |
| Re: Samsung Syncmaster 711MP LCD TV Monitor -Not Powering Up | [quote:e8914f791a="Anonymous"]I had Same problem. - Now Repaired -
Three of the Five Electrolyt |