| Subject | Text |
| [quote:5ce6f46df6="absorbentgnome"]The 120V AC bulb will be more 'efficient' because it is directly |
| DVD9000... Sure do remember the beast. Very nice & expensive unit. I use to work on them ..do ha |
|
|
| aiwa nsx-f9 | Can anyone help with a service manual for an aiwa nsx-f9 stereo or help with problem when connected |
| Panasonic CT-36SX12F | Your set blew a fuse back in OCT...
I have the same set ..
its about just over (2) years old & |
| Electronic equipment repair and service manual search discu | You can get L-pad attenuators for 100W. Google "100w lpad" and the first few results shoul |
| Heat Transfer Compound | It seem there are many different heatsink compounds on the market, silicon, zinc, hardsetting etc. N |
| sharp 27fs50 has sound but no pic anymore | Sharp model 27f-s50 has sound but no picture..turn the screen pot up at the screen and focus section |
| Re: Sony KV-A2911S TV | [quote:79c5707d21="robint"]Tv starts in black and white then goes into colour after a few minutes, g |
| This monitor requires bot the H-Sync and the V-Sync to be the correct way up ie +ve going or -ve goi |
| Sansui RZ-2500 service manual or schematics wanted | I have a Sansui RZ-2500 tuner/amp that only goes into standby mode but doesn't turn on. Any help ap |
| re; protect | Hi, one or both of your output IC`s are shorted, the unit is telling
you that it is in "protect mod |
| eprom dump supra stv28p10 | tv name: supra
tv model: ST28p10
Chassis name: 11ak19p5 (printed on right side of board) on back |
| Re: rca 46 inch again.... | [quote:73d50fc6d4="jloy1"]so in my previous post i had a high voltage arc from the center crt to the |
| TV Problem | :D
I have a 32" Sony projection TV. Latley when I turn it on I am getting sound but no picture. |
| Reinstall U31.
Disconnect other amp connector J7/MCON12.
Repeat resistance measurements to SAM |
| Bush 11AK19PRO Manual | Hey there,
Looking for a little assistance if poss.
Looking for a serice manual for bush 11AK1 |
| re; Sony | Hi, might also be IK circuit, try turning up G2/Screen control just a little to the right,
Larry E |
|
|
| Mag 810FD too bright | A hand-me-down from a friend. The monitor is too bright and adjusting brightness and contrast can't |
| There really are so many variables to even attempt to guess at the problem... the guy who gave it to |
| This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after pay |
| Need Service Manual for Pioneer VSX-D1S | If anyone has the service manual and/or schematics for this receiver/amp, I would be immensely grate |
| Not really. The LOPT, deflection and capacitors form a resonant circuit which produce the high volt |
| may be | may be this won't help but try yo unplug the tube ..clean pins and try again |
| Thanks madmatt2024 :idea:
I think you've given good suggestions & precautions, that's very |
| Mystery Diodes | Well I'm new here and athough I know alot about tube equiptment I have limited knowledge of solid st |
| Studioworks 775n (CB775BN) brightness adjustment??? | Hi all,
My monitor brightness controll is 100% on the OSD & my monitor is still darker than it |
| light bulb broke off the wires for main display | I have a 1995 RX-V850 Yamaha Stereo Rec. the through the hole light bulb has filaments not LED. that |
| This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after pay |
| Thanks. it's for a subwoofer box that has an amp of max 200w max output and i 'll be using a receive |
| philips l01.1e | hi all just wandering if some one could help me.?? i have a philips 32pw6006, it uses the L01.1e cha |