| Subject | Text |
| D826 and R817 | D826 and R817 I don"t know what is the part # of the diode the res. of resistor coz the no pri |
| Request for service manual Panasonic PVQ-2512 | I am a fairly old retired TV and Computer tech,since 1959, and I have vertical problem with my bedro |
|
|
| PVY4665RK | :roll: Larry, thank's for the vendor info. I will have no problem removing
and installing parts. Al |
| FOUND: Executech, DigiTech, HoTelephone, Americom manuals | Looks like I posted this in the wrong place first, moderator, please ignore or remove from ther othe |
| aiwa nsx-k580 | i need schematic diagram for aiwa nsx-k580 ,i have trouble in servo unit ,the slider does not work(n |
| Hp L1702 Monitor | Posted: Sat Dec 13, 2003 9:22 pm Post subject: Hp L1702 Monitor
--------------------------- |
| Mag LT765 LCD Monitor | I need service info or a schematic for a MAG 17" LCD monitor.
It started intermittently powering on |
| I'm Throwing a party !!!!!!! and need your help !!!! | Okay here's my dillema. My roommates and I are throwing a party next weekend and I'm trying to set |
| a10e | fault is probably the micro on the small signal panel ic7064, enter the service mode check the softw |
| Sounds strange to me that initially you could get a sweep across the screen either horizontally or v |
| Toshiba CX35d80, No sound | The Sound was very low at full volumn. Now there is no sound. Can I buy & replace a sound board? |
| SAMSUNG Microwave Oven CE245 (Board CE745/CE945) | Hi All! Micro Controller (Hitachi ######) is erased or damaged. Can I reprogram it? How can I get fi |
| Re: n2652w | [quote:387e1bae3c="freshman"]Hi All.
I have a viewsonic N2652w with a power supply that was dead
|
| CXA2043Q and CXA1907S | CXA2043Q and CXA1907S
Both of these parts are available at Bluestar in the US :
www.bluestar- |
| Hitachi | I find it unlikely that the parts are not there to fix it. No way would they have to replace the en |
| Part list says both are same part number. If they used whatever was available shrink tubing instead |
| I Have connector pinout | I have connector pinout+ eprom dump file :P [/u][/url][/list] |
|
|
| Re: Sony KV32FS100 Won't Power On | [quote:b778161fad="RJB"]My 32' Sony Vega won't power on. The Standyby Led continuesly blinks 5 times |
| look at [url]http://www.tehnic.go.ro/incarcator.htm[/url]
are there few schematic with accu charger |
| Dead Dell 1025HE | I'm attempting to repair a Dell 1025HE 17" monitor (essentially a Nokia 447S) for a friend.
sympt |
| THE TACTILE SWITCHES ON THESE TVS ARE PRONE TO GOING LEAKY. PUT THE TV INTO STANDBY WITH THE REMOTE, |
| Pioneer DV-F727 not reading discs. | i have a pioneer dv-f727 that is not reading discs. i took it to a repair
shop a couple weeks ago, |
| I've learnt something new, i tested the backlights by themselves when i got to them. they seem to wo |
| measuring high value resistor? | i have a 1.8 Mega Ohm resitor, my meter can read up to 2 mega ohm, but when i try and read the value |
| You can put a 12 volts 10 Watt lamp in series with the charger to limit the current to less than 1 A |
| Service Manual | Hi, I need a service o parts manual for canon s-100 printer o s-200 canon printer, thanks
Marco |
| Hi!
Sorry, I'm from Hungary, and my English is very bad.
Unfortunetly I have the same problem. M |
| carsofts | I HAVE MANY CAR SOFTS VAGDASHTOOL,DASH CALIBRATION,TACHOPRO,AIRBAG SOFTS.........I NEED TACHOSOFT CR |
| STRD6108E was specific to Panasonic & it's been discontinued, unless some supplier may have some |
| Practical Electronics Projects Design | http://www.electronics-project-design.com
The website above provides tips and references for elec |