| Make | Model | Problem | Solution | Date |
| | | |
| Found: 2116
|
| Aiwa | VX9142K | Dead | R516 270k in psu o/c | 14-09-04 |
| Aiwa | VXD1420 | Pin code removal | Enter wrong no 3 x, then press Vol- on set & "7" on R/C for 5 secs when "protected" appears | 14-09-04 |
|
|
| Aiwa | VXG142 | No raster - OSD OK | Q1029 near tuner | 14-09-04 |
| Aiwa | VXG142K | Dead - no st/by | R516 270K, IC501 TDA4605-3, Q500 2SK2397-01MR | 14-09-04 |
| Aiwa | VXG142K | Dead - no stby | R516 270k, IC501 TDA4605-3, Q500 2SK2397 | 14-09-04 |
| Aiwa | VXG142K | Dead with st/by led lit - accepts a tape but no functs | ICP506 1A CP on tv pcb o/c | 14-09-04 |
| Aiwa | VXG142K | Dead with fast tripping aft power cut | C513/C538 1m 160v in psu hi esr | 14-09-04 |
| Aiwa | VXG142K | No pic or vcr mechs - osd & sound ok | Replacing the faulty switching transistor Q511 [2SB926] which supplies the chroma +9V cured both faults. It is situated at the back LHS of the VCR board. | 14-09-04 |
| Aiwa | VXG142K | No sigs | Q1029 (2SC926) at rear of vcr pcb s/c - used a BD234 | 14-09-04 |
| Aiwa | VXS140 | Blank raster & no VCR funct except clock | FR551 [0.1 ohm 1/6 Watt] O/C | 14-09-04 |
| Aiwa | VXS140 | Lack of brightness on Video playback & off air | No 800V screen drive Increase FR752 from ( 1K ) to ( 1K5 ) PtNo 87022388060 | 14-09-04 |
| Aiwa | VXS140 | TV sect remains on (No st/by) | 115V power switching transistor Q550 [2SB816E] was S/C C-E | 14-09-04 |
| Aiwa | VXT1400KER | Red weak in pic | Replace C905, 7 & 9 1µ 50v in RGB drives | 14-09-04 |
| Aiwa | VXT1410 | St/by only | Dry joints power/stby key | 14-09-04 |
| Aiwa | VXT1410K | Poor start up from cold, patterning | C522 2µ 50v, C523 100µ 50v | 14-09-04 |
| Aiwa | VXT1420k | Dead | Start up Res R502 1M & R503 820k | 14-09-04 |
| Aiwa | VXT1420K | St/by only | LOPTr leaky | 14-09-04 |
| Aiwa | VXT1450K | Field collapse | FR812 3R9 1w fusible o/c - no other fault found | 14-09-04 |
| Akai | CT1417D | St/by only | C406 | 14-09-04 |
| Akai | CT1417UK | Field collapse | C411 leaky | 14-09-04 |
| Akai | CT1417UK | FRAME COLLAPSE | C411 LEAKY | 14-09-04 |
| Akai | CT2142VNT | Poor pic with fbck lines and curious col | IC301 pin 12 supply only 7v5 (9v1). R424 (0R68) hi res | 14-09-04 |
|
|
| Akashi | 1450 | Dead | Q811 SF8J41 reg thy s/c - used TAG626 as replacement | 14-09-04 |
| Akashi | 1450 | st/by only | R801 1R5 5w o/c | 14-09-04 |
| Akita | CW1492 | Int start up | R802/803 15k hi res | 14-09-04 |
| Akura | CX1400 | dead | ht to lop tr ok; ht low on line dr tr coll. Perm 5v on driver tr base due to non osc of x701 at pin 25 IC703 on dig pcb. Dry joint between xtal & chip | 14-09-04 |
| Akura | CX1400 | int functs - off, frame coll, st/by, blank raster | remove dig pcb and blanket resolder | 14-09-04 |
| Akura | CX1400T | Dead. | Q801 ( BUT11AF ) | 14-09-04 |
| Akura | CX1400T | Frame collapse. | IC301 ( TDA8172 ) , C302 ( 1000uf35v ) , C306 ( 2200uf25v ) | 14-09-04 |
| Akura | CX1400T | Int sound. | IC601 ( TDA1013B ) , C607 ( 220uf35v ) or C603 ( 1000uf25v ) | 14-09-04 |