Make | Model | Problem | Solution | Date |
| | | |
Found: 338
|
Aiwa | VXT1010K | Dead - goes into st/by | R515 3M3 , C517 C526 470uF 10v , C524 47uF 63v | 14-09-04 |
Aiwa | VXT1010K | Int sw on | Replace STK73907, C514 0µ082 pulse cap, Q501 2SK212, Q510 2SC1815. Change R520 to 68k & C524 to 220µ | 14-09-04 |
|
Aiwa | VXT1010K | No cold start up | C524 47µ 10v | 14-09-04 |
Akai | SP7101 | St/by only | Replace C093 sm (on print side) | 14-09-04 |
Alba | CTV701 | No sound/pic just blank screen with swirling lines | C917 100µ 160v | 14-09-04 |
Alba | Onwa CTV701 | No sound/pic just pattern on screen | Video reaching Txt pcb but not leaving it. 5v supply missing - check HT smoothing cap 100µ 160v | 14-09-04 |
Amstrad | CTV1401 | Buzz on sound/caption buzz | adj if o/p coil in tuner or replace tuner | 14-09-04 |
Amstrad | CTV1401 | Dist sound | R356 10k o/c | 14-09-04 |
Amstrad | CTV1401 | Interference bands across screen - affects other tvs in w/s | Mains sw | 14-09-04 |
Amstrad | CTV1401 | Tuning - drift. | Tuner unit. | 14-09-04 |
Amstrad | CTV1401 | Weak & distorted sound. | R356 ( 10k ) o/c | 14-09-04 |
Amstrad | CTV3012 | Int line - line drive low in fault condition | R601 4k7 hi res (12k) | 14-09-04 |
B & O | Beovision 8802 Type 7001 | Blank raster, no sound, OSD OK | R1 1,5Ohm o/c, TR1-TR2 BC 338-25 o/c, D1 13V Zener s/c
| 14-09-04 |
Beko | 30128T | Dead - LOPTr blown & twitching/flashing when replaced | R149 Surface mounted resistor should be 1K5, was up to 41K | 14-09-04 |
Beko | 30128T | Dead & ticking | BU508DF LOPTr s/c, C140 22n 630v o/c | 14-09-04 |
Beko | 30128T | Lop tr goes s/c | C140 22n 400v o/c | 14-09-04 |
Beko | NR30128T | Dead | LOPTx commonly goes faulty - SEME LOPTX35228P & R118 10k 1/2w burns out | 14-09-04 |
Beon | 1401 | Sound distorted | R153 82k hi res | 14-09-04 |
Beon | 2001 | Field collapse | R314/316 0R33 safety res o/c | 14-09-04 |
Beon | CTV2001R | Dead. | R109 ( 220ohm ) high or o/c. | 14-09-04 |
Beon | CTV2001R | Slow to come on. | R109 ( 220ohm ) high or o/c. | 14-09-04 |
Beon | CTV2001R | Squealing from PSU. | R109 ( 220ohm ) high or o/c. | 14-09-04 |
|
Beon | CTV2001T | Frame collapse. | R314 ( 3.3ohm ) o/c. | 14-09-04 |
Beon | CTV2101R | Standby only. | R108 ( 270k ) o/c. | 14-09-04 |
Binatone | 01/79014 | No Sound. | Speaker O/C. | 14-09-04 |
Binatone | 01/9014 | Dead - psu blow up | C607 47µ 25v caused it | 14-09-04 |
Binatone | 01/9014 | Sound dist at high vol | Q607 2SD400F reg should have 12v at emitter - only 5v at high vol - tr faulty | 14-09-04 |
Binatone | 01_9014 | No start up | R622/633 180k ?w o/c | 14-09-04 |
BPL | KLR9402-01 | St/by only | No line dr supply - R793 4K7 o/c | 14-09-04 |
BPL | LMR940201 | Dead - psu faulty | Replace 2SC3807 in base BU508 Power Tr & check green cap here for dry joints | 14-09-04 |