| Make | Model | Problem | Solution | Date |
| | | |
| Found: 898
|
| Aiwa | VXD2120K | Pin code resetting when lost | unplug set for 1 hour plus. reduce volume to minimum. simultaneuously press Volume down on unit and "7" to reset pin code and customer ID | 14-09-04 |
| Akai | CT2125 | Comes on with chirping noise & st/by led on then trips out after 1/2 min | C817 100µ 25v | 14-09-04 |
| Akai | CT2125 | Int blank raster with fb lines | OK when con TD203 on txt pcb removed - TZ01 27Mhz Xtal | 14-09-04 |
| Akura | CX12 | Dead set. | IC801 ( STR41090 ) | 14-09-04 |
| Akura | CX12 | Dead with squealing from PSU. | C412 ( 47uf100v ) o/c. | 14-09-04 |
| Akura | CX12 | Field non lin - cramped in centre | Supply to chip only 11v (22V) D813 BA157 leaky tho measured ok | 14-09-04 |
| Akura | CX12 | No pic - osd & sound ok | Check contrast setting - reset & store by holding down sw 002 by tuner | 14-09-04 |
| Akura | CX12 | No sound or raster - HT rail at 27v normally 112v | C828 ( 47uf 160v ) low. | 14-09-04 |
| Akura | CX12 | Psu makes noises | C828 47µ 160v o/c - check all thro pcb wire links | 14-09-04 |
| Alba | CTV11/12 | Dead | T301o/c, diode P600A o/c | 14-09-04 |
|
|
| Alba | CTV11/12 | Dead apart from display & HT | Dry joints T201, Q208 o/c | 14-09-04 |
| Alba | CTV11/12 | Int dead | R304 hi res | 14-09-04 |
| Alba | CTV12 | Dead - channel display ok | DJs on line driver transformer | 14-09-04 |
| Alba | CTV12 | Dead - Int dead - power-on light on. | R304 going high. | 14-09-04 |
| Alba | CTV12 | Dead - st/by only | LOPT DRY | 14-09-04 |
| Alba | CTV12 | Dead apart from chan display | Dry joints line dr tfmr | 14-09-04 |
| Alba | CTV12 | Dead. | T301 o/c , Diode P600A o/c. | 14-09-04 |
| Alba | CTV12 | Dead. | Dry joints on line driver transformer. | 14-09-04 |
| Alba | CTV12 | Dead. HT supply Ok. | Q208 Faulty. | 14-09-04 |
| Alba | CTV12 | No sound or picture channel display lit. | Dry on Line driver or LOPTX | 14-09-04 |
| Alba | CTV12 | No sound or picture. | Q208 12v reg o/c can use a TIP41. | 14-09-04 |
| Alba | CTV12 | No sound or raster - HT & display Ok. | D/J T201 ( looks Ok ) , Q208 o/c. | 14-09-04 |
| Alba | CTV12 | No sound/pic - HT normal | Q208 12v reg tr o/c - TIP 41 works ok | 14-09-04 |
| Alba | CTV12 | When removing back cover. | Check for screw inside rear foot ( underside ) | 14-09-04 |
| Alba | CTV6682 11AK12 | green flyback lines can be seen on the picture, otherwise is Okish | no green output from TDA8362A(2Y), the IC is u/s - caused by intermittently arcing LOPTx (HR6465). | 14-09-04 |
| Amstrad | 3121N 11AK12 | St/by only - psu o/ps present except 12 & 8v | IC301 (CTV352/V1.4) and IC302 (ST24C02AB1). | 14-09-04 |
| Amstrad | 3128N | Dead | C599 2,200pf s/c, Q101 BUZ90AF s/c, R101 5R6 5w o/c | 14-09-04 |
| Amstrad | 3128N | Hor black lines thro' pic | C454 10µ 25v o/c | 14-09-04 |
| Amstrad | 3128NF | Int pic break up | Line dr Tr replaced & increase feed res from 1 to 2k | 14-09-04 |
| Amstrad | CTV12 | Weak/no sound | R151 39k near lh edge of pcb o/c | 14-09-04 |