| Make | Model | Problem | Solution | Date |
| | | |
| Found: 1905
|
| Aiwa | VXT1000 | Dead TV sect | IC4 STK7348, R103 1R5 3w, R104 27R 3W, R105 1k 1/2w. C90 1µ 50v was to blame | 14-09-04 |
| Aiwa | VXT1000 | STK7348 chopper chip int fails | C88 3300pF 1kv can be the cause even tho' it looks ok | 14-09-04 |
|
|
| Aiwa | VXT1000 Mk2 | Dead | Ht ok at 120v - ICP1 o/c | 14-09-04 |
| Aiwa | VXT1000 Mk2 | Dead | STK7348 s/c pins 3 & 7, also R103 1R5 3W o/c, R104 27R 3w, R105 1k 1/2w & C90 1µ 50v | 14-09-04 |
| Aiwa | VXT1000 Mk2 | Dead - no line drive | D7 9v1 zener & C105 330µ 16v both s/c | 14-09-04 |
| Aiwa | VXT1000 Mk2 | Failure of IC STK7348 in tv psu | Replace:R102. 33ohmlW Part No S5 34A 330 000 R104 27ohm 3W Part No Sl 330 703 000(6.25UKP) RlOl 33ohm7W Part No Sl 330 862 000(8.37UKP) Also please check and if necessary replace:R103(3.76UKP) R105 Replace as required.
R109(4.00UKP) NOTE: Do not replace IC on its own.<< | 14-09-04 |
| Aiwa | VXT1000Mk2 | Dead | STK7348 psu chip & C88 0.0033pf 2kv | 14-09-04 |
| Aiwa | VXT1000Mk2 | Dead TV sect - vcr sect ok | C88 0.0033µ 1kv burnt; STK7348 psu chip s/c; R109 3R9 7w o/c | 14-09-04 |
| Aiwa | VXT1000Mk2 | No pic sound ok | C88 3n3 1kv burnt | 14-09-04 |
| Aiwa | VXT1000MkII | Sound no picture. | Replace IC4(STK7348) and C88(3n3 1kv). | 14-09-04 |
| Aiwa | VXT1010K | Dead - goes into st/by | R515 3M3 , C517 C526 470uF 10v , C524 47uF 63v | 14-09-04 |
| Aiwa | VXT1010K | Int sw on | Replace STK73907, C514 0µ082 pulse cap, Q501 2SK212, Q510 2SC1815. Change R520 to 68k & C524 to 220µ | 14-09-04 |
| Aiwa | VXT1010K | No cold start up | C524 47µ 10v | 14-09-04 |
| Aiwa | VXT1410 | St/by only | Dry joints power/stby key | 14-09-04 |
| Aiwa | VXT1410K | Poor start up from cold, patterning | C522 2µ 50v, C523 100µ 50v | 14-09-04 |
| Akai | CT2107MS (Onwa) | Int off with blob in centre of screen | Check for hairline cracks around chopper tfmr pins | 14-09-04 |
| Akai | CT2185-10 | St/by only | dry joints psu | 14-09-04 |
| Akai | SP7101 | St/by only | Replace C093 sm (on print side) | 14-09-04 |
| Akura | Baby 10 | Brightness - no control | D409 o/c | 14-09-04 |
| Akura | Baby 10 | Dead - list of psu 2 faults | Fault 1: Dry joints on IC402, also check 12V socket.
Fault 2: Line output transistor is dry jointed (emitter).
Fault 3: Check if fuse holder 5AT is loose.
Fault 4: Replace D410 in line stage with two RGP30 in parallel.
Fault 5: Check regulator block for dry joints.
Fault 6: Check D410 (FR604) in the line output stage. | 14-09-04 |
| Akura | Baby 10 | Dead - list of psu faults | Fault 1: Check output of regulator IC402. S/C in DC jack may blow the 5A/T fuse. Note: IC402 can cause other faults, such as oversized picture with bent verticals.
Fault 2: Check L110 for dry joint.
Fault 3: [No 12V at regulator]. Check R402 (1R/0.5W) for O/C.
Fault 4: Check line drive transformer (TX EM103) for dry joints.
Fault 5: Check print between output and destination of (potted) regulator for O/C.
Fault 6: Check line output transistor for broken print.
Fault 7: Check fuse F402 and diode D402, damage due to incorrect connection of battery.
Fault 8: Replace IC402. Check EEprom chip IC601 (MN1220).
Fault 9: Check regulator IC401 (L7812).
Fault 10: Check the DC input sockets for high resistance.
Fault 11: [5A fuse blown]. Check D412 FR155 diode for S/C a BY299 will do.
Fault 12: [Regulator OK]. Check line drive transformer for dry joints.
Fault 13: Check mains transformer for O/C.
Fault 14: [630mA fuse by switch O/C]. Check bridge rectifier for S/C. Use 1N5401 as replacement.
Fault 15: Check IC402, F401 (630mA) fuse and D403, D405 in the bridge rectifier circuit.
Fault 16: [F401 blown]. Check D404.
Fault 17: [No PSU start up]. Check resistors R301 (330K) and R302 (330K).
Fault 18: Check 12V DC-IN socket. | 14-09-04 |
| Akura | CX10 | Dead - no standby light. | R402 high. | 14-09-04 |
|
|
| Akura | CX10 | Dead apart from relay click | 15v across C403 1000µ but only 3v at reg o/p - IC402 AL271 reg | 14-09-04 |
| Akura | CX10 | No picture. | Efficiency diode FR605. | 14-09-04 |
| Akura | CX10 | No sound or picture. | DC converter IC ( it has a massive heatsink ) | 14-09-04 |
| Akura | CX10 | No sound or picture. | D410 s/c also check R320 ( 33R ) if higher change it. | 14-09-04 |
| Akura | CX10 | Tuner low gain | R114 150k & R119 56k or IC201 TAY680AP but then is temp dependent | 14-09-04 |
| Akura | CX10 (Baby 10) | Int dead | Dry joints inside discrete type reg module | 14-09-04 |
| Alba | CTV10 | dead | mains tfmr o/c pri | 14-09-04 |
| Alba | CTV10 | Dead - st/by only | D410 OC LOPT SC | 14-09-04 |