| Make | Model | Problem | Solution | Date |
| | | |
| Found: 17
|
| Beko | 11221T | Dead | psu working - no line drive - line dr tfmr | 14-09-04 |
| Beko | 1220T | Field lin | R725 150k dry joint | 14-09-04 |
| Beko | 12220 | Blank screen with buzzing & Thy overheats | R725 hi res | 14-09-04 |
| Beko | 12220 | Col int | Dec panel plugs int | 14-09-04 |
| Beko | 12220 | Int pic/sound - disappears with flashing on screen and noise thro speaker | Xtal Q701 in front of IC701 | 14-09-04 |
| Beko | 12220 | Top ? of screen lit, rest blanked | R717 1M o/c also check R722 1M | 14-09-04 |
| Beko | 12220 | Top quarter of screen lit & blank - rest black | R717 1M o/c - connected to pin 5 TEA2029 also check R722 in series 1M | 14-09-04 |
| Beko | 12220 | Trips off at sw on - HT = 125v on bulb | D801 BY299 s/c - LOPTX could be the cause | 14-09-04 |
| Beko | 12220 10.2 | Front cont int don't work | Check momentary contacts on mains sw | 14-09-04 |
| Beko | 12220NX | Status info perm/semi perm displayed | Q2 17.47 Mhz Xtal on audio pcb drifting | 14-09-04 |
|
|
| Beko | 12220NX | The status information appeared on the scrcen at r | The cause of the fault was on the audio panel , where the 17.47MHz crystal Q2 was drifting when warm.§ | 14-09-04 |
| Beko | 12220T | Dead 55v HT | D111 FR30-02 S/C, U4 supply diode | 14-09-04 |
| ITT | C5122 Core 110 | Flashing pic & no tuning on highest chans | 33v Tuning reg | 14-09-04 |
| Philips | GR1AX 14GR1221 | Dead | resistor 3300 4R7 o/c.cap 2301 4,7uF 350V s/c on multi voltage pcb | 14-09-04 |
| Philips | GR1AX 14GR1227/05B | Dead - HT at 1.5v at power supply whistling | Replace SF2D41 protection thyristor (6641) | 14-09-04 |
| Samsung | CI50122 | St/by only | C808 100uF 16V, C817 100uF 25VW, C811 10uF 63VW | 14-09-04 |
| Thorn | CT5122 | Low volume - in "Hotel" mode | to release: Select vol up or down on TV & whilst bargraph is displayed, press"-/--" key on handset | 14-09-04 |