| Make | Model | Problem | Solution | Date |
| | | |
| Found: 39
|
| Fidelity | WSTV3132NF | Dead - LOPTr s/c - when replaced only low buzzing/no EHT | EHT lead s/c (has bleedere as'y fitted) | 14-09-04 |
| Fidelity | WSTV3132NF | Dead with s/c LOP Tr & safety res burnt | IC801 TDA8380 R805-R809 1R opto CNX82A, R821 8R2 ,R814 47R,Q840, BC501Q used BC639, R841 1k2,Q810 BUW13,R815 10k,Q601 BU508A & replace eht bleed assembly with regular eht lead as original is obsolete | 14-09-04 |
| Philips | 21PT132A | No OSD | Replace TDA8361E with TDA8362E - arcing from R3456 caused failure | 14-09-04 |
| Sanyo | CTP132 | Top foldover | C44 4µ7; C447 10µ | 14-09-04 |
| Sanyo | CTP6132 | Dead | F301 800mA o/c; Q304 chopper tr s/c;C308 100µ was the cause | 14-09-04 |
| Sanyo | CTP6132 80P | Frame foldover at top. | C440 ( 4.7uf ) also change C447 ( 10uf ) | 14-09-04 |
| Sanyo | CTP7132 | Field collapse | C445 ( 2 , 200uF ) | 14-09-04 |
| Sanyo | CTP7132 | Line TR s/c | C312 ( 10uF ) o/c | 14-09-04 |
| Sanyo | CTP7132 | No sound | C321 1000uF 35v OC | 14-09-04 |
| Sanyo | CTP7132 80P | Line OP transistor s/c. | RESOLDER HEATSINK IF FAULT REOCCURS REPLACE D305 IN POWER SUPPLY AND POSSIBLY LOPT | 14-09-04 |
|
|
| Sanyo | CTP7132 80P | Dead with s/c LOP TR | Check connection to heatsink plate on main pcb & D305 zener in error detector cct - causing HT to rise | 14-09-04 |
| Sanyo | CTP7132 80P | East west - fault R4012 burnt. | R4012 ( 2.2R ) Q4005 s/c , R4011 burnt , EW coil L4001 s/c. | 14-09-04 |
| Sanyo | CTP7132 80P | LINE OP TR SC | RESOLDER HEATSINK IF FAULT REOCCURS REPLACE D305 IN POWER SUPPLY AND POSSIBLY LOPT | 14-09-04 |
| Sanyo | CTP7132 80P | TRIPS SLOWLY | C312 10uF | 14-09-04 |
| Sharp | DV5107H DV5132 D | NO SYNC OR NO COL , NVM DATA COUPT | ADD 8.2v ZENER BETWEEN PINS 5 AND 8 OF IC1003 CATHODE - PIN 8 Sharp RH-EX0413BMZZ | 14-09-04 |
| Sharp | DV5132 | No power , the HT was corning up but the set was t | R612 was opencircuit. A replacement restored norrnal operation. | 14-09-04 |
| Sharp | DV5132 | St/by only unless you persevere with sw on | Field collapse briefly appears - No 28v to FOP chip TDA8175 as R612 2R2 1/2w o/c | 14-09-04 |
| Sharp | DV51322H | Int pic | R751 & 777 0R33 1w & C756 2200µ 25v | 14-09-04 |
| Sharp | DV5132H | Dead - blows chopper tr at sw on | Chopper tfmr s/c turns pins 2 & 7 | 14-09-04 |
| Sharp | DV5132H | Dead with LED flashing between red & green | A common problem is due to R751 & R777 (both 0.33R) increasing in value by only a small amount. Best to substitute them rather than relying on meter checks. Sharp also advise replacing D751,D700,C756 and/or R612 at the same time. | 14-09-04 |
| Sharp | DV5132H | Dead with led flashing red/green | R751 0R33 safety res had doubled res value | 14-09-04 |
| Sharp | DV5132H | IN PROTECTION MODE THEN SBY | CHECK R612 FUSIBLE SUPPLY TO FIELD IC | 14-09-04 |
| Sharp | DV5132H Deco 5 | Bright raster then shuts down at sw on | No 200v to crt pcb - C857 100pF leaky & R632 o/c | 14-09-04 |
| Sharp | DV5132H Deco 5 | Dead - R705 3k3 fusible o/c | Check 725 39R for hi res | 14-09-04 |
| Sharp | DV5132H Deco 5 | Lack of height | IC1400 RH-IX1426BMNO on digital pcb | 14-09-04 |
| Sharp | DV5132H Deco 5 | Trips at sw on | R612 3R3 safety res o/c | 14-09-04 |
| Sony | AE-1B KVX2132U | reduced height | R802 0.47R | 14-09-04 |
| Sony | AE1B KVX2132U | Lines over bright parts of pic & rolling | Q598 in video amp circuit faulty, C592 100µ was the cause. | 14-09-04 |
| Sony | KVX2132U | Pic fades out & crackle on sound - other tvs in w/s pick up radiation | LOPTx internal arcing | 14-09-04 |
| Sony | SCC-132B | Blank picture for while then starts from bott | C816 ( 4.7u f , 250v ) | 14-09-04 |