| Make | Model | Problem | Solution | Date |
| | | |
| Found: 11
|
| Goodmans | 2025RS | 3 defocussed col rings fill screen | IC301 TDA8356 Field osc is outputting at line rate - chip u/s | 14-09-04 |
| Goodmans | 2025RS | Bright R, G or B raster | Replace TDA6101Q on crt base | 14-09-04 |
| Goodmans | 2025RS | Dead symptom although PSU runs - no st/by LED | No reset pin 15 IC1701 due to no o/p pin 6 IC1802 TDA8138 - faulty | 14-09-04 |
| Goodmans | 2025RS | DEAD WITH NO STANDBY LIGHT POWER SUPPLY RUNNING | REPLACE IC1802 | 14-09-04 |
| Goodmans | 2025RS | Dead, no st/by but PSU running ok | No reset pin 15 IC1701 due to no o/p pin 6 IC1802 TDA8138 - faulty | 14-09-04 |
| Goodmans | 2025RS | Excess of 1 pri col - no pic | TDA6101Q driver IC | 14-09-04 |
| Goodmans | 2025RS | Int bright raster with fb lines after warm up | C910 4µ7 in 200v supply | 14-09-04 |
| Goodmans | 2025RS | No pic, sound ok, if A1 volts adj pic appears but missing next time sw on | I501 TDA8374A (no RGB I/p to CRT base - o/p at 1v instead of 4.5v) | 14-09-04 |
| Goodmans | 2025RS | No pic, sound ok, if A1 volts adj pic appears but missing next time sw on | I501 TDA8374A (no RGB I/p to CRT base - o/p at 1v instead of 4.5v) | 14-09-04 |
| Goodmans | 2025RS | Pic goes bright white int | 200v supply to CRT base varies due to C910 4µ7 leaky or dry joints | 14-09-04 |
|
|
| Goodmans | 2025RS | THREE COLOUR RINGS COVER ENTIRE SCREEN | REPLACE IC301 | 14-09-04 |