| Make | Model | Problem | Solution | Date |
| | | |
| Found: 12
|
| Goldstar | 2168F | FIELD CRAMP , LINE ACROSS SCREEN | C309 ( TANT ) 0.22mfd | 14-09-04 |
| Goldstar | CIT2168 | Dead | LOPTx shorted turns | 14-09-04 |
| Goldstar | CIT2168 | Dead - 118v HT low at 50v | C806S 47µ 160v HT smoothing cap | 14-09-04 |
| Goldstar | CIT2168 | Field collapse - int | Pin 5 TDA1170N was 5v instead of 25v. D301 1N4003 faulty. If chip turns out to be faulty use genuine Goldstar chip (others won't work - allegedly) Also check R320 10R 1w | 14-09-04 |
| Goldstar | CIT2168 | Int start up | D401 1N4003 o/c in line dr supply | 14-09-04 |
| Goldstar | CIT2168 | No start up | Check R811P 22k 3w, D805P R10J in start up cct, C805P 100µ 16v | 14-09-04 |
| Goldstar | CIT2168 | Sound muted & goes to Stby after 10mins. | Replace the TDA1940 IC401 remove the link J8 & fit 1k instead. | 14-09-04 |
| Goldstar | CIT2168 | Txt absent | Dry joints conn P102 on txt pcb | 14-09-04 |
| Goldstar | CIT2168F | Field foldover | C423, C302 100µ 35v | 14-09-04 |
| Goldstar | CIT2168F CIT2190F etc | No sound - pic ok - sw to st/by aft 10 mins | Pin 7 IC401 TDA1940 produces muting o/p - chip u/s. Fit 1k res in place of J8 link | 14-09-04 |
|
|
| Sanyo | CBP2168 | Int goes blank raster & no sound | Check 5v st/by supply present - sus st/by tfmr pri | 14-09-04 |
| Sanyo | CBP2168 | No front controls so no tuning possible - R/C ok | D710. 711 6v2 zeners leaky on main pcb | 14-09-04 |