| Make | Model | Problem | Solution | Date |
| | | |
| Found: 14
|
| B & O | LX2800 | Blank raster & no sound - OSD OK | C18 on decoder board dry joint | 14-09-04 |
| B & O | LX2800 37XX | Sync - poor sync. | 26IC5 ( TDA1940 ) | 14-09-04 |
| Grundig | CUC2800 | Arcing from LOPTx former to adjacent components | Tripler faulty | 14-09-04 |
| Grundig | CUC2800 | Dead - psu working ok | Relay contacts | 14-09-04 |
| Grundig | CUC2800 | No sound | Check TDA6200 sound proc & U2829B sound dem chip | 14-09-04 |
| Grundig | CUC2800 | Sound from one chan only & no brill adj | Micro SDA2011-A005 faulty | 14-09-04 |
| Grundig | CUC2800 | Sound low & dist | U2829B IC sound chip | 14-09-04 |
| Grundig | CUC2800 | The tripler had failed. After replacing it the set | Microcontroller chip type SDA2011 -AOO5 . Make sure that you get the right one for the set. | 14-09-04 |
| Proline | 2800 | FIELD COLLAPSE | CHECK OP. IC uPC1498H | 14-09-04 |
| Proline | 2800 - 3200 | VERY LOW HEIGHT - 4 " . | CHECK -20v LINE ( PIN 8 - LOPT , R 456 etc. ) | 14-09-04 |
|
|
| Proline | TN2800 | flyback lines on the top | C428 100uF 35V next to frame IC | 14-09-04 |
| Proline | TN2800 | Lines at top of screen | Flyback boost cap C432 100µ 35v | 14-09-04 |
| Proline | TN2800 | no sound when cold, then distorted, then Ok after 6-7 min | replace IC701 LA7955 situated on the AV PCB | 14-09-04 |
| Proline | TN2800 | not memorising channels | check for -28V on pin 28 and +5V on pin 8 of IC106, if these are correct, replace IC101 OEC8032B and IC102 MN1220 | 14-09-04 |