| Make | Model | Problem | Solution | Date |
| | | |
| Found: 16
|
| Bush | 2868NTX | aft scan coil plug burn up | L604 (should measure 2R7) | 14-09-04 |
| Bush | 2868NTX | Hum bar third way down screen | Reposition degaussing coils | 14-09-04 |
| Bush | 2868NTX | Snowy raster, reduced width - won't access service mode, won't tune & locks up if pic menu entered | EEPROM replaced - part no. AB30001610 from CPC | 14-09-04 |
| Bush | 2868NTX | St/by only | Faulty EEPROM was the cause | 14-09-04 |
| Bush | 2868NTX 11AK08 | Child Lock removal | use default pin code 734. | 14-09-04 |
| Bush | 2868NTX 11AK12 | Child Lock removal | Dis pin 5 of EEPROM, sw set on, go to menu & set up any new pincode you like (do not forget to memorise it). While set is still on, re-connect pin 5 of EEPROM & press STORE on R/C. Now sw set off, resolder back the EEPROM and new pin is the one what you just entered. | 14-09-04 |
| Bush | 2868NTX 11AK19 | Child Lock removal | go to the menu and toggle the child lock between on/off | 14-09-04 |
| Bush | 2868NTX 11AK19 | Dead | R806 22k o/c also R825 2M2 o/c | 14-09-04 |
| Bush | 2868NTX 11AK19 | Dead with LOPTr s/c | Check conns to scan coil plug - if overheated, wire directly | 14-09-04 |
| Bush | 2868NTX 11AK19 | E/W correction faulty | Q683 FET BUK444 faulty | 14-09-04 |
|
|
| Bush | 2868NTX 11AK19 | Entering service mode | Select "Install" then key in "4, 7, 2 & 5" via hset | 14-09-04 |
| Bush | 2868NTX 11AK19 | No pic - sound ok - pic will appear briefly when adj A1 | C604 47nF 63V s/c in beam current | 14-09-04 |
| Bush | 2868NTX 11AK19-5 | E/W faulty | C630 470nF | 14-09-04 |
| Bush | 2868NTX 11AK19-5 | No tuning - pic settings wrong | Replace with blank eeprom & set up with hex code | 14-09-04 |
| Bush | 2868NTX 11AK19-5 | Txt absent apart from "100" | Replace multi micro/text chip SDA5255-A047 available from cHS | 14-09-04 |
| Bush | 2868NTX 11AK20 | Child Lock removal | press P+ and P- on front 5 times | 14-09-04 |