| Make | Model | Problem | Solution | Date |
| | | |
| Found: 11
|
| Bush | 1433/34/35 | DEAD | Q801 S/C R809 O/C. REPLACE BOTH THESE AND R804/805 AND IC801 | 14-09-04 |
| ITT | Ideal color 3332GR | Won't start, going to stby. | Change polyester cap C709 connected between B-E of horizontal output Tr. Shorts hor. drive to ground | 14-09-04 |
| Philips | MD1.2E AA 28PW63332/05 | Line collapse | Burnt conns on deflection yoke plug/skt | 14-09-04 |
| Toshiba | 2539DB, 2939DB, 3339DB | Contrast changes when playing DVDs with Macrovision | Add 10k res between pins 54 & 61 of IC501 & R211 from 1k to 4k7 | 14-09-04 |
| Toshiba | 3339B | No display, signal, only snow with fb lines when A1 advanced | chopper sec 25v supply prot ZP81 o/c due to s/c audio chip (IC670) TA8218AH - missing 25v also feeds 5v reg & used as supply for prot circuitry | 14-09-04 |
| Toshiba | 3339DB | Bright pic with fb lines | Adj of A1 or focus improves - caused by faulty crt | 14-09-04 |
| Toshiba | 3339DB | Dead | Q823[2SC3297], Q822[2SA11608], Q824[2SC1815] s/c in psu & R872 [3R 15 W] o/c.
this got the psu running ,but ht was only 70v should be 125v [disconnect lopt and supply came up]. replacing lopt completed cure. | 14-09-04 |
| Toshiba | 3339DB | NOISE FROM CENTRE SPEAKER WHEN SWITCHING TO STANBY | NOT FAULTY SWITCH OFF PROLOGIC | 14-09-04 |
| Toshiba | C2D 3339DB | big "bump" noise when switching to stby | not faulty. Switch off pro-logic before switching to stby (info from Toshiba technical) | 14-09-04 |
| Toshiba | C2D 3339DB | hiss/crackle from left speaker | ICG07 TA8776N | 14-09-04 |
|
|
| Toshiba | C2D 3339DB | tripping, red and green LEDs flashing at about 3Hz | Q828 2SC2230AY leaky (can use 2SC2482 as replacement from Onwa CRT base) | 14-09-04 |