| Make | Model | Problem | Solution | Date |
| | | |
| Found: 176
|
| B & O | 3600 | Blue Picture | 16R1 ( 1.5Mohm ) | 14-09-04 |
| B & O | 3600 | No E-W Correction | 6D5 ( BY299 ) | 14-09-04 |
|
|
| B & O | 3600 | No Picture - Failureof Line o/p Transitor | 0C1 ( 9.1nf ) | 14-09-04 |
| Daewoo | CP330/CP365 | Magenta cast after I501 replacement | I501 TDA4661 chroma delay line chip could be faulty | 14-09-04 |
| Daewoo | CP330/CP365 | No pic or line drive | Check drive pin 37 I701 TDA8362B, if none check 8.2v pin 36, if present replace chip, if absent check R401/2, D401 | 14-09-04 |
| Daewoo | CP330/CP365 | Txt absent/garbled | XT01 27Mhz Xtal | 14-09-04 |
| Daewoo | CP365 | Int loss of signals - OSD ok | Dry joints chopper tfmr | 14-09-04 |
| Daewoo | CP365 | Int signals | Dry joints sec of chopper tfmr | 14-09-04 |
| Daewoo | CP365 | Sound - int crackle | Invisible dry joint C808 270pF 1Kv - pin 3 pri of chopper Tx | 14-09-04 |
| Ferguson | 36MK48TV | Dead | No HT at cathode of DP20 - CP36 dry joint | 14-09-04 |
| Ferguson | 36MK48U | To put set in service mode | Switch set to StBy , switch off ( with on/off switch ) and switch on whilst holding down blue fastext button , press blue but | 14-09-04 |
| Ferguson | A36R | Width int | Dry joints cap CP18 | 14-09-04 |
| Ferguson | C3615U Combi | Switches off aft 10 secs with tape jammed | RW002 1R 1w safety res on deck pcb - also check fuse link FW003 (behind on/off sw near white ribbon conn) | 14-09-04 |
| Ferguson | C3615UT | Hotel mode removal | Press simultaneously on the PR-, STOP and AC on/off button on the front of the combi. Adjust using arrow keys on the remote, press ok. | 14-09-04 |
| Ferguson | C3615UT | Hotel mode reset | Press PR-, STOP & AC on/off button on front of combi. Adj using arrow keys on R/C, press ok. | 14-09-04 |
| Ferguson | C3615UT | No R/C response | 3 legged IR Rx faulty | 14-09-04 |
| Ferguson | C3615UT | Txt int lost | QX51 27Mhz Xtal on Txt pcb replaced | 14-09-04 |
| Ferguson | TX807 M3615UT | Dead apart from red LED pulsing - In Child Lock | To release - Sw on TV at mains whilst holding in Magenta Txt key | 14-09-04 |
| Ferguson | TX807 M3615UT | LED stays green for 6 secs at sw on then reverts to st/by | DL04 BY288 in E/W mod cct leaky | 14-09-04 |
| Finlux | 3621 | PATTERNING AT LOW BRIGHTNESS LEVELS OF PICTURE | CG46 470uF 16v | 14-09-04 |
| Finlux | 3621 | White patterning on dark scenes | Noise on 7v rail - CG46 470µ 16v | 14-09-04 |
| Finlux | 3621F | NO PICTURE OR SOUND RASTER OK | TDA2450-2 ICi2 US CHECK 11v ON PIN 3 | 14-09-04 |
|
|
| Finlux | 3621F | No sound/pic "P100" appears in txt mode | ICi2 if chip TDA2450-2 | 14-09-04 |
| GEC | C2036H PIL | No neons on touch-tune. | IC202 ( SN70769N ) | 14-09-04 |
| GEC | C2236 20AX | Brightness excessive. | R281 ( 82k ) on decoder PCB ( can use 2x39k ) | 14-09-04 |
| GEC | C2290H 2036 Hit | Dull raster may not have any colour. | IC ( TDA3561A ) decoder. | 14-09-04 |
| Goldstar | CF25C36 NC51B | Wont stop when in search - existing chans may be slightly off tune | IC182 5v reg producing low o/p | 14-09-04 |
| Goldstar | CIS4361 | No picture - sound ok | no crt htrs due to taernished pins on 4 pin connector by Loptx | 14-09-04 |
| Goldstar | CIS4361 | No picture. | 4 Pin connector by LOPT pins tarnished ( feed to heaters ) | 14-09-04 |
| Goodmans | 215N CP365 | Buzz on audio - unaffected by vol setting | Dry joints FOP heatsink | 14-09-04 |