Make | Model | Problem | Solution | Date |
| | | |
Found: 17
|
Goodmans | 5160 | BRIGHT WHITE SCREEN | 100mfd CAP ( MAY BE C659 - SITUATED RIGHT SIDE CENTRE BETWEEN P.SUPPLY AND LOPT. NEAR REGULATORS ) | 14-09-04 |
Goodmans | 5160 | Excess brightness | C629 100µ 25v | 14-09-04 |
|
Panasonic | CN516 | Dead - in prot mode | When prot mode disabled, only scan bottom 1/3rd of screen due to D412 27v zener MA4270H s/c | 14-09-04 |
Sharp | 4BSA DV5161H | int. goes to stby | resolder blue tuning cap C610 near LOPTx | 14-09-04 |
Sharp | 4BSA DV5161H | unstable line output from cold, no teletext | EEPROM IC1002 (CHIX1463CJHA), Q1010 BC338 o/c B-E, R604 3k3 0.33W o/c | 14-09-04 |
Sharp | DV5161H | Blows lop tr aft few mins | Tuning caps C607, 608, 609 & 610 | 14-09-04 |
Sharp | DV5161H | Dead - loptr s/c - R604 flaming | R649 15R 1W across Q1010 coll/emitter hi res & replace R604 3k3 1/3w safety res | 14-09-04 |
Sharp | DV5161H | Dead green LED lights briefly flashing red | Dry joints C610 near LOPTx | 14-09-04 |
Sharp | DV5161H | Electronic Screwdriver | Wire link pins 3 & 6 of plug TB on txt panel. Press "mode" on hset. "Serv" appears on screen. Remove link & use up/down buttons to view menu settings. Press "Mode" button again to exit settings | 14-09-04 |
Sharp | DV5161H | HEIGHT VARIES WITH PIC CONTENT FIT MODS , ADD 270K | ADD 110K 1/8W BETWEEN CATHODE OF D801 AND GROUND , - CHANGE C832 TO 100nf , CHANGE NVM TO NEW SOFTWARE VERSION ( Sharp CH-IX1 | 14-09-04 |
Sharp | DV5161H | No sound/pic - screen lit with lines with half screen darker | FOP chip - gets hot! | 14-09-04 |
Sharp | DV5161H | St/by only | No 12v supply; D602 1N4936 o/c | 14-09-04 |
Sharp | DV5161H | White raster with fb lines & trips | R612 22R fusible o/c | 14-09-04 |
Sharp | DV5161H | WORKS FOR 1min THEN SHUTS OFF. ALL SECONDARY SUPPL | C711 1n 2kv | 14-09-04 |
Sharp | DV5161H 4BSA | Field foldover, bright raster then collapse of pic & shut down when warm | Line drive started to break up (IC801 pin 12); 26v supply low at 19v - D501 DX0511BM faulty | 14-09-04 |
Sharp | DV5165H | Dead - lop tx faulty - when replaced screams | IC751 7805 5v reg chip faulty ( only gives out 4v) | 14-09-04 |
Sharp | DV5165H | Int blows chopper & LOPTr | C751 100µ 200v - int arcing? | 14-09-04 |