| Make | Model | Problem | Solution | Date |
| | | |
| Found: 8
|
| Sharp | 51DS-02S CA10 | Dead | Q602 (BUH515) & both audio amps IC2300 & 2301 (TDA7480) s/c, also C720 100uF/200V) blown top. | 14-09-04 |
| Sharp | 51DS-02S CA10 | HT high at 200v (112v) | Opto IC705 (MOC8106). | 14-09-04 |
| Sharp | 51DS02 | GREEN PATCHES AND STRANGE COLOURS ON BRIGHT SCENE | ENTER SERVICE MODE (HOLD VOL- AND CH+ AND SWITCH ON) SELECT PAGE 00 AND SET POS 04 TO 24 POS 05 TO 2C AND POS 06 TO 4B | 14-09-04 |
| SHARP | 51DS02H | NO SOUND | REPLACE IC104 SHARRRHIX1588BMZZ | 14-09-04 |
| Sharp | 51DS02H | St/by only & no control of front controls | R705 68k micro feed o/c | 14-09-04 |
| Sharp | 51DS02H CA10 | Sound absent | corrupted EEPROM (8-pin SMD IC104 24C16) due to DJ on LOPTx earthing pin (focus, screen pots). | 14-09-04 |
| Sharp | 51DS02H CA10 | When replacing EEPROM | switch set on, after 10 sec delay whilst micro writes data, tune all the channels & select weakest then sw off tv. To enter service mode hold Ch+ & Vol- on front panel while switching mains on. Set comes on in service mode on weakest chan, using ch+/- on R/C choose "AGC take over" in menu & press STANDBY, set will adjust AGC automatically.
Now correct geometry if reqd.& press STANDBY to memorize. To exit service mode simply switch off. | 14-09-04 |
| Sharp | CA10 51DS02H | no sound | IC104 NVM24C16 (RHIX1588BMZZ) | 14-09-04 |