Make | Model | Problem | Solution | Date |
| | | |
Found: 10
|
Binatone | 01/79014 | No Sound. | Speaker O/C. | 14-09-04 |
Binatone | 01/9014 | Dead - psu blow up | C607 47µ 25v caused it | 14-09-04 |
|
Binatone | 01/9014 | Sound dist at high vol | Q607 2SD400F reg should have 12v at emitter - only 5v at high vol - tr faulty | 14-09-04 |
Binatone | 01_9014 | No start up | R622/633 180k ?w o/c | 14-09-04 |
Decca | 8901 | Tripping or HT low ( Should be 115v or 109v ) may start up correctly if scan coils unplugged . | C803 220uF 16v ( PSU IC supply ) OC. | 14-09-04 |
Goldstar | KBV-9012E TV/VCR Combo | White raster with retrace lines, the set switches off after a while. L901 (in series with +180V supply to RGB trs) oc, the +180V winding of Loptx delivers 300V!! (Di&smooth.Cap OK) | Replace C820 10uF/160V cap. Note that +180V supply delivers 300V, while +B and all other voltages are normal. Seems to be a weird LOPTx fault, but it was C820 instead. | 14-09-04 |
Goldstar | KBV-9012E TV/VCR Combo | White raster with retrace lines, the set switches off after a while. L901 (in series with +180V supply to RGB trs) oc, the +180V winding of Loptx delivers 300V!! (Di&smooth.Cap OK) | Replace C820 10uF/160V cap. Note that +180V supply delivers 300V, while +B and all other voltages are normal. Seems to be a weird LOPTx fault, but it was C820 instead. C820 IS NOT the smoothing cap for +180V. | 14-09-04 |
Harwood | HTV9014R | Tripping | EM112 st/by tfmr o/c winding | 14-09-04 |
Kyoto | K/MTE9014 | Overloading and unstable picture and muted sound | Replaced C116 on Pin 18 of TDA4505E a .47uf | 14-09-04 |
Sony | AE1 KVM2901E | Slow start up from cold | Check C605 (220µF/35V), C617 (100µF/50V), D617 in the start up circuit along with C605 (220µ). | 14-09-04 |