| Make | Model | Problem | Solution | Date |
| | | |
| Found: 43
|
| Orion | Triade 34 | Dead - blows bridge rect | Fit 4 x BYD33M, 150µ smoothing cap chopper tr & TEA2261 | 14-09-04 |
| Panasonic | Euro 2 TX25AD1DP | Dead - PSU tripping | Unplugging W7002 on audio panel allows set to power up - fault on audio psu - R7000 180k & R7005 150k o/c | 14-09-04 |
| Panasonic | Euro 2 TX25AD2 | Field collapse | VDP IC pt no TZS9EK002 comes with new EPROM approx ?30 | 14-09-04 |
| Panasonic | Euro 2 TX25AD2 | Lack of width with E/W corr faulty | C593 0.01mfd ceramic cap | 14-09-04 |
| Panasonic | Euro 2 TX25ADT | Col absent apart from bits of pink/green | VDP3108A | 14-09-04 |
| Panasonic | Euro 2 TX29AD1 | No sound/pic just ticking from relay | could be LOP fault but relay faulty in this case | 14-09-04 |
| Panasonic | Euro 2 TX29AD1DP | Bright red raster which went to field collapse then tripped off | Dis pins 5 & 6 of EEPROM I941 & re-try. If pic returns, albeit short, then EEPROM faulty. Reqs reprog or a pre prog one fitting (X24C0706AH - Pan- cheapest, or SEME). Also replace relay TSE10818 - cause of initial trouble & remove R668 | 14-09-04 |
| Panasonic | Euro 2 TX29AD1DP | Dead with psu tripping | C622 47µ 50v, C634 1µ 50v | 14-09-04 |
| Panasonic | Euro 2S TX29AD2DPB | Blank greenish raster with lines at top lh side - sound ok | IC601 VDP3108APPA1 jungle IC (42.22UKP) | 14-09-04 |
| Panasonic | Euro 2S TX29AD2DPB | Burst of eht at switch on then trips off after about 7 secs with frame collapse visible just as it went off | IC601 VDP3108APPA1 jungle IC (42.22UKP) | 14-09-04 |
|
|
| Panasonic | Euro2 TX21AD2/M | Relay clicks on & off in regular fashion | C807 100µ 25v hi esr | 14-09-04 |
| Panasonic | EURO2S TX25AD1DP | AFTER REPLACING EEPROM SET COMES ON TO CHANNEL 0 AND 'NORMAL' SETTINGS WILL NOT MEMORISE | PRESS TOGETHER 'STATUS' ON R/C AND 'FUNCTION' AT FRONT OF TV. THE SET WILL RUN 'SELF-TEST'. SWITCH THE SET OFF, THEN BACK ON AND RE-TUNE | 14-09-04 |
| Panasonic | EURO2S TX25AD1DP | dead, tripping | Q651 O/C (PART NO. TFD312S0F632) | 14-09-04 |
| Panasonic | EURO2S TX25AD1DP | E/W fault | Q593 BC847B S/C | 14-09-04 |
| Panasonic | EURO2S TX25AD2DP | dead, no startup | 5V SUPPLY TO IC1801LOW BECAUSE IC1601 AN78L05TA FAULTY (5V REGULATOR) | 14-09-04 |
| Panasonic | EURO2S TX25AD2DP | no sound, no pic, led pulsing dim-bright | relay RL6101 (TSE10818) faulty, replacement from Goodmans 1430 works OK | 14-09-04 |
| Panasonic | EURO2S TX25AD2DP | trips to stby every 2-3 secs, frame collapse | I601 VDP3108APPA1 | 14-09-04 |
| Panasonic | EURO2S TX25AD2DP | won't go to stby | Q667 BC547B o/c | 14-09-04 |
| Panasonic | EURO2S TX29AD1DP | excessive width with E/W error | Q593 BC547B | 14-09-04 |
| Panasonic | EURO2S TX29AD2 | tripping, red LED flashing, relay operating | fault caused by sound power supply not running and pulling down SCL3 data line. Replace R2502, R2503 150k on K board | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | in autosearch won't store BBC1/BBC2 | BBC changed channel No ID, replace EEPROM IC1871 with new software (27C010A09C) | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | int. horizontal black lines from top to bottom of screen | D507/D508 MA723TA5 leaky | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | no audio, faint noise from all speakers in all modes (tuner and AV) | replace IC1301 MSP3410-15TV (multisound processor) | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | no sound from centre or rear speakers (only quiet hum) | the +19V line down to +10V, replace IC2505 TDA2030AV , also check IC2506/IC2517 | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | no surround sound | IC506 TDA2030 | 14-09-04 |
| Panasonic | EURO2S TX29AD2DP | won't go to stby, sound mutes and odd row of dots float down screen | replace relay RL6001 (TSE10818) on front control PCB | 14-09-04 |
| Panasonic | EURO2S TXxxAD1DP | dark pic with int. sparkling from the CRT base | replace P362 preset brightness control on the CRT base | 14-09-04 |
| Panasonic | TX21MD1, TX21AD2, TX25MD1,
TX28LD1, TX25AD1, TX25AD1DP,
TX29AD1, TX29AD1DP | Black & white vert lines - replace VDP3108 | Orig IC601 nla - use kit TZS9EK002-2, which includes EEPROM with nec software changes to use VDP3108APPA1 | 14-09-04 |
| Panasonic | TX25AD1/DP | No pic - only 3 hor lines across screen 10cm separation | 1st dis pins 4&5 of Earom(24CO706A) & check if field comes back.It did along with E-W errors which proves FOP chip ok so replace VDP3108 kit part no TZS9EK002-2 | 14-09-04 |
| Panasonic | TX25AD1DP | DARK PICTURE WITH SPARKING | CHECK BRIGHTNESS CONTROL ON CRT BASE | 14-09-04 |