| Make | Model | Problem | Solution | Date |
| | | |
| Found: 13
|
| Goodmans | C100 | LOW GAIN - SLIGHT HUM BAR - PICTURE ALSO PULLS ACR | CHECK AROUND HT POT FOR drys or diodes | 14-09-04 |
| Grundig | GSC100 | Dead - blowing 3.15 fuse - intermittently. | EHT cap arcing. | 14-09-04 |
| Grundig | GSC100 | Dead - blowing 3.15amp fuse. | EHT cap jumping across to degaussing coil. | 14-09-04 |
| Grundig | GSC100 | Dead. | R607 o/c , faulty thyristors , insulation in line o/p stage. | 14-09-04 |
| Grundig | GSC100 | Dead. | Di511 or C2502 ( 100u f , 16v ) on EHT control regel baust PCB. | 14-09-04 |
| Grundig | GSC100 | Frame - bottom foldover - cramping at top. | R2522 ( 2.2k ) goes high. | 14-09-04 |
| Grundig | GSC100 | IF EHT IS VERY HIGH | CHECK DI508 IS OPEN | 14-09-04 |
| Grundig | GSC100 | Line break up. | C2502 ( 100uf , 16v ) on EHT control regel baust PCB. | 14-09-04 |
| Grundig | GSC100 | No frame. | Di447 ( 1N4007 ) and/or TDA1170. | 14-09-04 |
| Grundig | GSC100 | R607 - repeated resoldering of R607. | Di2502 ( 4.7v ) zener. | 14-09-04 |
|
|
| ITT | CVC100 | dead with whistling only from psu | No 115v HT - 120v zener D658 leaky | 14-09-04 |
| Sharp | C1001 | Black thumbprint superimposed over top of pic | R429 in blanking cct | 14-09-04 |
| Sharp | C1001 10" Port | CORNER OF PICTURE MISSING | R429 HIGH IN BLANKING CCT | 14-09-04 |