| Make | Model | Problem | Solution | Date |
| | | |
| Found: 12
|
| Sharp | BCTVA DV5935H | dead, LOPTr s/c | C712 100uF 50V, L700 VPCF3R3K0000-1, R715/R734 0.56R 2W (VRN-VV3DBR56J), IC700 MC44602 (RHIX1487BMZZ), Q705 2SD1546, Q600 2SD1546, D718 1N4732 (RHEX0487BMZZ) | 14-09-04 |
| Sharp | BCTVA DV5935H | stuck in stby | LOPTr Q600 2SD1546, C619 (marked C617) 0.56uF 250V swollen (RC-FZ6564BMNJ), R619/R632 39R 0.5W burnt. Check pin 11 of IC500, if s/c replace IC500 TDA8350Q (RHIX1471BMZZ) | 14-09-04 |
|
|
| Sharp | BCTVA DV5935H | takes about 10 presses to switch on | R721 5R6 gone high | 14-09-04 |
| Sharp | BCTVA DV5935H | text vibrates after frame IC replaced | wrong type IC used, use RHIX1471BMZZ | 14-09-04 |
| Sharp | DV5932 DV5935 | NO SOUND , PIC. GEOM. WRONG. | RESET NVM SETTINGS | 14-09-04 |
| Sharp | DV5932H DV5935 | Stuck in standby. | CRACKED PRINT AROUND LOPT T600 | 14-09-04 |
| Sharp | DV5935 | Dead - R632 & 619 39R burnt | Replace also C619 0µ56 250v & resolder L603 & check 2SD1546 loptr & scan coils conns | 14-09-04 |
| Sharp | DV5935 | Low width, poor e/w, field cramp | C607 & L604 | 14-09-04 |
| Sharp | DV5935H | CHANGES TO FIELD CCT . | C516 HAS BEEN REMOVED , L500 HAS BEEN CHANGED TO 180R 0.5W RESISTOR Pt No -XZ0227BMZZ | 14-09-04 |
| Sharp | DV5935H BCTV-A | Dead - chopper tr Q705 2SD1546 & IC700 MC44602 chopper control chip both s/c | C712 100µ low cap, D708 & its feed res burnt up; now no sec supply to 12v rect as T700 chopper trfmr damaged | 14-09-04 |
| Sharp | DV5935H BCTV-A | Dead - Q600 2SD1546 LOPTr s/c | R619 39R ?w & R632 39R ?w fusible burnt; C607 0µ56 line scan coupling cap o/c | 14-09-04 |
| Sharp | DV5935H BCTV-A | St/by only | LOPTr Q600 2SD1546, C619 560nf 250v & check R619/632 39R safety res | 14-09-04 |