Make | Model | Problem | Solution | Date |
| | | |
Found: 301
|
Ferguson | TX807 Proline 1415 | blue line on LHS of pic | replace TV04 BC848B | 14-09-04 |
Ferguson | TX807 Proline 1415 | dead, no LED | DP26 BAV21 leaky causing start-up voltage to drop to zero | 14-09-04 |
|
Ferguson | TX807 Proline 1415 | dead, TP20 s/c and RP01 o/c | replace DP21 (80444020), DP27 (60447870), RP01 (10547070), TP20 (20818740), TP22 (16000930), TP25 (16001110) | 14-09-04 |
Ferguson | TX807 Proline 1415 | dead, tripping | replace SMD RL41 22k (CPC order RE00095) | 14-09-04 |
Ferguson | TX807 Proline 1415 | int. blank raster with 6 coloured lines across screen | CV16 100nF in V-ramp int. going o/c (CPC order code CA01939) | 14-09-04 |
Ferguson | TX807 Proline 1415 | line collapse | replace CL06 33nF 250V | 14-09-04 |
Ferguson | TX807 Proline 1415 | low brightness/contract | BCL inoperative, RL65 o/c (Ferg. Part no 80437780) | 14-09-04 |
Ferguson | TX807 Proline 1415 | pic appears briefly but scan not right and out of focus, then cuts into stby and tries again | RL45 1R fusible o/c | 14-09-04 |
Ferguson | TX807 Proline 1415 | small pic, top half to one side, cannot be fully adj. In service mode | replace EEPROM IR02 (Ferg. Part no 20159470) | 14-09-04 |
Ferguson | TX807 Proline 1415 | stuck in stby | replace LOPTx (20840590) | 14-09-04 |
Ferguson | TX807 Proline 1415 | tripping, LED 4 secs red - 4 secs green | DL04 BY228 leaky | 14-09-04 |
Ferguson | TX807 Proline 1415 | tripping, LED flashing red/green | DL25 BZV85C27 27V zener (measures Ok) | 14-09-04 |
ITT | C5122 Core 110 | Flashing pic & no tuning on highest chans | 33v Tuning reg | 14-09-04 |
ITT | Compact D-E 110 | Pic brighter on one side | C522 100µ 25v | 14-09-04 |
ITT | Core 110deg | Dead - st/by LED gives 1 quick flash at sw on | LOPTx - code TFHR6175 CPC | 14-09-04 |
ITT | Core 110deg | Int off - HT 145v (95v) 24v=14v; 16v ok | C723 2n2 4kv was not soldered in properly | 14-09-04 |
ITT | Core 110deg | No front panel controls - R/C ok | T1454 BC328 leaky | 14-09-04 |
ITT | Core 110deg | Pic pulling esp at top | C527 100µ 35v, C522 100µ 25v | 14-09-04 |
JVC | 14E1EK Onwa | Dead | Chopper Tr 2SD1545 leaky | 14-09-04 |
JVC | C14E1 | Self destructs every few days | C910 0µ1 in chopper sw on pulse shaping | 14-09-04 |
JVC | C14E1EK | Bright pic | ZD301 | 14-09-04 |
JVC | C14E1EK | Dead | C907 small disc cap 0µ1? burnt & R901 4R7 5w o/c | 14-09-04 |
|
JVC | C14E1EK | Dead - st/by only | ZD402 s/c; replace the following:- ZD402, R423, C909, ZD902, C911, ZD901, D408 to prevent HT rising & blowing parts again | 14-09-04 |
JVC | C14E1EK | Dist sound | C143 10µ o/c in dc vol contr feed to pin 14 IC101 | 14-09-04 |
JVC | C14E1EK | FAINT HORIZONTAL LINE AT BOTTOM OF SCREEN | REPLACE R434 0.047 OHM | 14-09-04 |
JVC | C14E1EK | Field collapse | 25v supply to fop chip LA7830 IC401 missing - R433 0R68 o/c & C424 4n7 500v leaky (measured ok out of cct) | 14-09-04 |
JVC | C14E1EK | field collapse after psu repair | speaker plug connected to service pins by mistake | 14-09-04 |
JVC | C14E1EK | Field o/p chip IC401 LA7830 int destroyed | VR901 2k HT preset int - causing HT to int rise | 14-09-04 |
JVC | C14E1EK | FRAME COLLAPSE | CHECK R335 180K FOR O/C | 14-09-04 |
JVC | C14E1EK | Incorrect AGC | C124 | 14-09-04 |