| Make | Model | Problem | Solution | Date |
| | | |
| Found: 11
|
| Goodmans | W280NS Formenti F19 | Service mode access | Sw on TV holding in Vol+. Release vol button & press St/by on r/c within 3 secs. To save settings press yellow "mem" button else press TV/AV to exit without saving changes | 14-09-04 |
| JVC | AV29SX1EN | No sound | Replace IC 952 (5V REG for audio control , Dolby,etc) | 14-09-04 |
| Proline | 1485R Daewoo Formenti | No line drive | I501 micro u/s Part no 1DW3813DE1 | 14-09-04 |
| Proline | 1485R Daewoo Formenti | Reverts to st/by aft 65 secs | I501 micro u/s Part no 1DW3813DE1 | 14-09-04 |
| Proline | 28N1 Formenti F19 | Dead - Chopper FET short. R8 O/C 390k | also replace TR1 P60NB80PF, | 14-09-04 |
| Proline | 28N1 Formenti F19 | Vol cont bar will not move above 3 notches (not in hotel mode) | EEPROM corrupt - enter service mode by pressing "vol up" on TV whilst sw set on & within 3 sec's press "standby" on R/C (still holding "vol up"). Service mode options now on screen. Make a note of settings!! Scroll up to "INIT CTVFOR-P V1.3" press "vol up" (toggle) & wait 2 sec's to finish. | 14-09-04 |
| Proline | F205T Formenti PC230 | Dead - mains i/p fuse blown | C415 1nf 1kv (blue pulse type) situated near the SMTX on the primary side. It was split | 14-09-04 |
| Siemens/Blaupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | Set can not be switched to Stby with the remote control. All other functions O.K | Switch the TV to Stby from the on/Stby switch on the front panel.Hold down the"ME" button and switch the TV on.Press CS. It should work normally now. | 14-09-04 |
| Siemens/Blaupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | To set normal values for Bright/Contr/Col/Volume | Switch set to Stby. Hold down "ME"button, until set switches on. Adjust bright,contr etc and press "ME" again to memorise. | 14-09-04 |
| Siemens/Blupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | Set can not be switched to Stby with the remote control. All other functions O.K | Switch the TV to Stby from the on/Stby switch on the front panel.Hold down the"ME" button and switch the TV on.Press CS. It should work normally now. | 14-09-04 |
|
|
| Siemens/Blupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | To set normal values for Bright/Contr/Col/Volume | Switch set to Stby. Hold down "ME"button, until set switches on. Adjust bright,contr etc and press "ME" again to memorise. | 14-09-04 |