| Make | Model | Problem | Solution | Date |
| | | |
| Found: 14
|
| Salora | L series | Arcing, pops & lines | Dry joints C512 & R606 | 14-09-04 |
| Salora | L series | Blank raster & no sound | Check TDA 4505 ICB101 & CB117 22n | 14-09-04 |
| Salora | L series | Blank raster OK when Txt panel dis'd | check continuity of wire links through panel & DPU2540 chip | 14-09-04 |
| Salora | L series | Can tune in chans but no store | MDA2062 memory chip | 14-09-04 |
| Salora | L series | Cracking noise & collapsing pic | Dry joints C511, 512 & 507 in lop stage | 14-09-04 |
| Salora | L series | Dead with squel | DN08 BY228 in lop s/c | 14-09-04 |
| Salora | L series | Front controls do the wrong things | Re-enable and store, if this fails replace SAA1293 & MDA2061 | 14-09-04 |
| Salora | L series | Herringbone pattern down side of pic | CB616 1000µ 17v reservoir supply | 14-09-04 |
| Salora | L series | Int blank raster with no sound | CM39 on print side of pcb shorting to tracks | 14-09-04 |
| Salora | L series | Int line cogging | Line hold pot int | 14-09-04 |
|
|
| Salora | L series | Int pic disturbance | Traced to break within R179 100k | 14-09-04 |
| Salora | L series | No luminance | Lum delay line (in a can) | 14-09-04 |
| Salora | L series | No signals - IF chip TDA4505 switched off (pin 19 low instead of 6v) | RB135 330k o/c & check CB131 1µ | 14-09-04 |
| Salora | L series | Slow start up | CN10 1000µ in psu | 14-09-04 |