Make | Model | Problem | Solution | Date |
| | | |
Found: 184
|
Goodmans | 1465TS L6.1 | Dead - psu blown due to EHT lead arcing in LOPTx | Fit PSU kit 482231010663 & LOPTx 482214010562 & LOPTr | 14-09-04 |
Goodmans | 1465TS L6.1 | Weak contrast - black vert lines | C2427 33nF 250v in beam lim | 14-09-04 |
|
Goodmans | 256/286 L6.3 | Dead with loud whistling | C2912 2n2 2kv on 110deg module burnt - Pt no 482212613451 | 14-09-04 |
Goodmans | 256/286 L6.3 | Field collapse | 3928 1R 1/2w fusible o/c (behind LOPTx) | 14-09-04 |
Goodmans | 256/286 L6.3 | No E-W & lack of width | 7908 STP4NA40F1 s/c on deflection panel - Pt no 482213063725 | 14-09-04 |
Goodmans | 256/286 L6.3 | St/by only | 6503 BYD33D leaky, 1502 0.63A fusible hi res (causes low volts to jungle chip) | 14-09-04 |
Goodmans | 256/286 L6.3 | Txt & OSD rolling - pic stable | IC7600 micro SAA5296P8/095 - replace with SAA5296P8/217 pt no 482220917219 | 14-09-04 |
Goodmans | 256/286 L6.3 | Txt shifted laterally - sometimes wont find page | 2606 100n sm cap leaky or o/c | 14-09-04 |
Goodmans | 256NS L6.3 | E/W faulty with hum & burning smell | C2913 causing hum, Q3924 causing E/W fault | 14-09-04 |
Goodmans | 256NS L6.3 | Line collapse | R3930 560R safety res o/c, C2915 390nF 250v o/c | 14-09-04 |
Goodmans | 256NS L6.3AA Chassis | E/W dist | C2913 (390n 250v) and 7908 (STP4NA40F1) mosfet | 14-09-04 |
Goodmans | 286NS (Philips L6.3 chassis) | No sound - noise only from speakers | MPS3410 chip faulty - replaced audio pcb | 14-09-04 |
Goodmans | 286NS L6.2 | Pic break up with sound muted | LOP stage volts down 10 volts at 140V. R3509 47K in PSU O/C. | 14-09-04 |
Goodmans | 286NS L6.2 | Pic shifted to left; RV3120 no effect - Txt OK | Crack in print to RV120 | 14-09-04 |
Goodmans | 286NS L6.3 | Blows BU1508AX | Loptx faulty pt no 482214010623 | 14-09-04 |
Goodmans | 286NS L6.3 | Comes on then pic disappears into snow, sound ok then sw itself off etc | Replace 7505 BC337/40 & 7500 BC858B(situated on print side by 7505) also replaced 22uf 2511. | 14-09-04 |
Goodmans | 286NS L6.3 | Dead - buzzing | L4520 gone hi pt no 482215750965, T7906 BU1508AX s/c | 14-09-04 |
Goodmans | 286NS L6.3 | Dead - no LED | C2915 390nF 250v | 14-09-04 |
Goodmans | 286NS L6.3 | E-W faulty | Replaced C2913 & C2915 | 14-09-04 |
Goodmans | 286NS L6.3 | Ext 1 or 2 can't be selected using "0" button | 24C02AB1 EEPROM | 14-09-04 |
Goodmans | 286NS L6.3 | Field collapse | R3908 2R2 0.33w o/c | 14-09-04 |
Goodmans | 286NS L6.3 | Field partial collapse | R3988 2R2 fusible o/c | 14-09-04 |
|
Goodmans | 286NS L6.3 | Int comes on at sw on | R3512 68k, R3513 330k, R3518 120k start up res | 14-09-04 |
Goodmans | 286NS L6.3 | Lack of width, line speed off, no field sync | IC7100 TDA8361 | 14-09-04 |
Goodmans | 286NS L6.3 | Line collapse | C2915 390nF o/c, R3929 220R & R3930 560R burnt | 14-09-04 |
Goodmans | 286NS L6.3 | St/by only | Fusible 1502 o/c, when replaced Field collapse - crack in print to 7422 opto coupler | 14-09-04 |
Goodmans | 286NS L6.3 | St/by only - faint buzzing | Cct Prot 1502 o/c pt no 482225251185 | 14-09-04 |
Goodmans | 286NS L6.3 | St/by only - line drive unstable | Diode 6503 BYV10-40 leaky | 14-09-04 |
Goodmans | 286NS L6.3 | St/by only, 5v line pulsing | D6505 BZX79C5V1 | 14-09-04 |
Goodmans | 286NS L6.3 | Txt shifted laterally | 5420 15µH coil pt no 482215750965 | 14-09-04 |