| Make | Model | Problem | Solution | Date |
| | | |
| Found: 11
|
| B & O | MX2000 | Bright on lh side, dark on right then goes completely dark | Dry joints pin 1 LOPTx | 14-09-04 |
| B & O | MX2000 | Dead TEA2026 defective | LOPTx desroys chip so replace as well & replace or fit 15v zener between o/p pin 7 chip & chassis | 14-09-04 |
| B & O | MX2000 | Faint pic after LOPTx replacement | RL25 burnt | 14-09-04 |
| B & O | MX2000 | Slightly off tune at sw on | Back up battery on its way out - if no startup after replacement s/c battery terms momentarily | 14-09-04 |
| B & O | MX2000 | White hor line 3-5 cm tall | No 200v on crt base - dry joints pin 9 LOPTx | 14-09-04 |
| B & O | MX2000 3119 | St/by only (dot in display) | 124v HT present no line drive as RP10 1R2 hi res | 14-09-04 |
| B & O | MX2000 31XX | Bright raster with no sound. | RL28 1.5ohm dry. | 14-09-04 |
| B & O | MX2000 31XX | INT FIELD COLLAPSE | DRY JOINTS ON EW DIODES OR ON CL12 | 14-09-04 |
| B & O | MX2000 31XX | No picture. | Drys on CRT base. | 14-09-04 |
| B & O | MX2000 31XX | No sound. | 6Mhz coil LD40 o/c. | 14-09-04 |
|
|
| B & O | MX2000 31XX | Standby - no standby light. | RP43 0.47ohm o/c , CR67 ( 1 , 000uf ) on microcomputer PCB8. | 14-09-04 |