| Make | Model | Problem | Solution | Date |
| | | |
| Found: 93
|
| FERGUSON | T49F | STUCK ON STANDBY | CHECK DL05 FOR LEAK DIOD1S1834 | 14-09-04 |
| Ferguson | T49F/TX91 | HEIGHT DECREASES AFTER 1 HOUR | REPLACE CF06 100MFD50V | 14-09-04 |
| Ferguson | TX91 T49F | Height decreases when heated | CF06 100µ 50v | 14-09-04 |
| Ferguson | TX91 T49F | St/by only | DL05 1S1834 leaky in 13v supply | 14-09-04 |
| Goldstar | CIT4175 | St/by only - dead when sw on | No line drive - D812 1N4003 o/c | 14-09-04 |
| Goldstar | CIT4785 | Dark pic with field non lin | C820 HT cap 10µ 160v | 14-09-04 |
| Goldstar | CIT4785 | Field collapse | 40v wform at pin 2 of LA7830 chip - check C305 100µ 16v | 14-09-04 |
| GOLDSTAR | CIT4785 | Int dead | dry joints chopper chip (looked ok) & check other dries in psu | 14-09-04 |
| Goldstar | CIT4785 | Int no sound/pic/field collapse - display stuck on "0"; no r/c or front controls | int s/c on 12v line - P101 pin 11 s/c to adj pin | 14-09-04 |
| Hinari | CT4 | Channels - changing & Picture flashing. | Dry joints on front unit. | 14-09-04 |
|
|
| Hinari | CT4 | Dead | R406 680R o/c | 14-09-04 |
| Hinari | CT4 | DEAD + WHINING | LOPT | 14-09-04 |
| Hinari | CT4 | Dead apart from whining sound | LOPTx faulty | 14-09-04 |
| Hinari | CT4 | Dead. | Check for drys on L406 , R406 ( 680ohm ) o/c. | 14-09-04 |
| Hinari | CT4 | Lop overload | Loptx u/s even tho measured ok on tester | 14-09-04 |
| Hinari | CT4 | No luminance | coil across CF101was o/c | 14-09-04 |
| Hinari | CT4 | No or distorted sound. | Speaker s/c if so Q608 ( BC337 ) Q602 ( BC328 ) leaky/ s/c. | 14-09-04 |
| Hinari | CT4 | No sigs - tuner faulty | Replacement ?25+ so used U341 in lieu stuck to side of orig - note connections reversed | 14-09-04 |
| Hinari | CT4 | Smeary pic | RGB o/p coll volts low, L501 10µH hi res | 14-09-04 |
| Hinari | CT4 TLG0101 | Loud whining noise from L/H side. | LOPTX | 14-09-04 |
| Hinari | CT4 TLG0101 | No frame. | R313 ( 8.2ohm ) o/c , Q310 , Q301 ( 2SA940/2SC2073 ) . | 14-09-04 |
| Hinari | CT4/5 | Front display inop, no sigs or front functs | No 5v - D426 BA157 s/c supply from LOPTx | 14-09-04 |
| Hinari | CT4/5 | Int sound with crackle | Check IF screening can fitted correctly | 14-09-04 |
| Hinari | CT4/5/6 | Tuning critical for colour | Adj tuning then adj AFC coil L131 | 14-09-04 |
| JVC | AV28WT4 | St/by only with ECO light flashing | B1 sec read s/c; E/W cct s/c due to D521, C470 & Q466 | 14-09-04 |
| NEC | PXT-42S11S | NEC PXT42S11S 42" plasma, hooked it all up and then turned it on. All I got was a white screen with "Heat Run" in red letters in the top left hand corner which disappeared to leave me with a blank white screen. No matter which buttons I press, I still jus | Sounds like the LVDS cable from the mainboard to the panel has come disconected might have been vibration during transport.
| 27-12-05 |
| Philips | 20CT4626/05T | Cracking & banging. | Drys on LOPTX. | 14-09-04 |
| Philips | 21PT4456 | St/by only | FOP chip TDA9302H | 14-09-04 |
| Philips | 25PT410/05 AA5AB | Tuning drift | C2037, a 220nF SMD on pin 44 of IC7015 (near tuner) also if not locking check adj of AGC preset & coil L5040 near IC7015 | 14-09-04 |
| Philips | 25PT4101/05 | E/W dist | R32484 4R7 1/2w | 14-09-04 |