| Make | Model | Problem | Solution | Date |
| | | |
| Found: 68
|
| Alba | CT840 | Dead | R302 6k8 high res | 14-09-04 |
| Alba | CT840 | Dead | R302 6k8 in psu o/c | 14-09-04 |
|
|
| Broksonic | CTSGT8118T | Dead, Q501 2SD2578 s/c | When replaced, came on with bright white raster - IC45 TDA6107Q & R996 (10R 1/2w?) | 14-09-04 |
| Contec | KT8135 | Bright pic with fb lines | R406 A1 control no effect - R474 390k on crt base o/c | 14-09-04 |
| Contec | KT8135 | dead | R504 68k in psu o/c | 14-09-04 |
| Contec | KT8135 | Dead | R501, R502 330k & R503 1M faulty | 14-09-04 |
| Contec | KT8135 | Dead - fuse's ok. | Fuse ok - R501 or R502 ( both 330k ) o/c. | 14-09-04 |
| Contec | KT8135 | Field lin problem | C336 220µ 50v | 14-09-04 |
| Contec | KT8135 | No luminance. | Poor plug connection for luma on CRT base panel. | 14-09-04 |
| Contec | KT8135 | Snowy pic | SAWF int or dry jointed | 14-09-04 |
| Contec | KT8250 | dead - chan display and relay click present | R504 330k in psu o/c | 14-09-04 |
| ITT | Compact 80 | dead | LOP Tr BU208A leaky - check C713 4µ7 63v | 14-09-04 |
| ITT | Compact 80 | Int goes into / won't come out of st/by | Dry joints 5v reg on R/C panel | 14-09-04 |
| ITT | Compact 80 | Int goes into st/by aft 1 min | Disabling electronic fuse gets tv going; Replace both tr's in electronic fuse (701/702 - BC238B) | 14-09-04 |
| ITT | Compact 80 | Lines at bottom of pic with whistling/vibration from chopper tfmr | C713 4µ7 63v | 14-09-04 |
| ITT | Compact 80 | No sound or chan display- blank raster | All secondary supplies slightly low; no 12v to control panel. IC521 12v reg on back of CMR800 | 14-09-04 |
| ITT | Compact 80 | Pulling pic | C212 10µ cap in CMR800 (near top of can) | 14-09-04 |
| ITT | Compact 80 | Pulling/bouncing pic | 2 x 10µ & 1 x 100µ caps in CMR803 middle sect | 14-09-04 |
| ITT | Compact 80 | Ringing on verticals | C733 10µ 160v | 14-09-04 |
| ITT | Compact 80 | Spots on pic | Comes & goes when focus pot tapped - pot faulty | 14-09-04 |
| ITT | Compact 80 | St/by only | C703 10µ 50v | 14-09-04 |
| ITT | Compact 80 | St/by only | OK on dummy load with scan coils removed - CRT soft | 14-09-04 |
|
|
| ITT | Compact 80R | Dead | C701, D712 & D714 | 14-09-04 |
| ITT | Compact 80R | Dead with electronic fuse tripped | C703 or s/c LOPTx or s/c on LOP supply lines | 14-09-04 |
| ITT | Compact 80R | No pic - no scastle pulse at decoder | T401 BC238B | 14-09-04 |
| Morphy Richards | CT870 | Dead | D304 efficiency diode u/s - used RGP10 | 14-09-04 |
| Philips | 29PT828C | STUCK IN STANDBY | RESOLDER SCAN COIL PLUGS | 14-09-04 |
| Philips | 29PT828C | TRIPS FROM GREEN LED TO RED TO GREEN TO RED | REPLACE IC7450, AND IC7550 ON AUDIO PCB | 14-09-04 |
| Philips | 29PT8319 | Corrections on service manual EM1A AA | Page 4 Chapter 2:
It was forgotten to mention here in this chapter that the architecture is 'hot'for a big part.
E,g. deflection is 'hot', but also the middle big heatsink. So be warned.
Page 16 Chapter 5:
SAM-menu on right hand top side, sho | 14-09-04 |
| Philips | 29PT8419 | Corrections on service manual EM1A AA | Page 4 Chapter 2:
It was forgotten to mention here in this chapter that the architecture is 'hot'for a big part.
E,g. deflection is 'hot', but also the middle big heatsink. So be warned.
Page 16 Chapter 5:
SAM-menu on right hand top side, sho | 14-09-04 |