| Make | Model | Problem | Solution | Date |
| | | |
| Found: 78
|
| Ferguson | TX805 | Blank raster | M52038SP multifunction chip IL01 | 14-09-04 |
| Ferguson | TX805 | bright pic with fb lines | 10R safety res for 150v supply o/c & CP22 22µ 100v dried up | 14-09-04 |
|
|
| Ferguson | TX805 | Dark pic with ringing | dry joint at Y I/p on crt base | 14-09-04 |
| Ferguson | TX805 | Dead | CHECK RP41 - RP44 68Ks | 14-09-04 |
| Ferguson | TX805 | Dead | CHECK RP 41 , 42 , AND 44 150k AND 120k IN PARALLEL. | 14-09-04 |
| Ferguson | TX805 | Dead | RP92 - 0.68 ohms | 14-09-04 |
| Ferguson | TX805 | Dead | DP18 ( BA159 ) RP68 ( 0.68ohm ) | 14-09-04 |
| Ferguson | TX805 | Dead | D412 S.C. FITTED UNDER HEATSINK | 14-09-04 |
| Ferguson | TX805 | Dead | DP50 150v zener s/c; RP08 115k o/c | 14-09-04 |
| Ferguson | TX805 | Dead - tripping slowly | CHECK LT TO FIELD SUPPLY | 14-09-04 |
| Ferguson | TX805 | Dead - mains fuse blown, S2000AF TP10 s/c | Check DP50 150v prot diode (from pin 3 loptx to chassis). If faulty check DP10 BYV38, RP92 0R68 fusible res, DP90 BA157, DP21 2.7v zener, CP08 100µ 35v & loptx | 14-09-04 |
| Ferguson | TX805 | Dead - no st/by led | RP44 68k ?w in psu o/c | 14-09-04 |
| Ferguson | TX805 | Dead stuck in st/by | DP18 BA157 & RP68 0R68 in 15v supply u/s | 14-09-04 |
| Ferguson | TX805 | Dead with s/c S2000AF loptr | RP28 2R7 5w o/c; DP11 BA157 s/c | 14-09-04 |
| Ferguson | TX805 | Dead. | CHECK RP 41 , 42 , AND 44 150k AND 120k IN PARALLEL. | 14-09-04 |
| Ferguson | TX805 | Dead. | RP92 - 0.68 ohms | 14-09-04 |
| Ferguson | TX805 | Dim pic | RC23 150k o/c | 14-09-04 |
| Ferguson | TX805 | Distorted / Poor sound. | Check RA10 is correct ( 680ohm ) not 6K8. | 14-09-04 |
| Ferguson | TX805 | FIELD FLYBACK LINES | CHECK RES JP20 MARKED AS 680r 33r IN SET. SERIES WITH 100mfd | 14-09-04 |
| Ferguson | TX805 | Flyback lines. | Check resistor JP20 marked as 680R 33R in set. series with 100uf. | 14-09-04 |
| Ferguson | TX805 | INT SHUTTING DOWN OR DEAD | CHECK 15V SUPPLY RESISTORS | 14-09-04 |
| Ferguson | TX805 | Low brightness. | RT40 68K gone high , on CRT base. | 14-09-04 |
|
|
| Ferguson | TX805 | No pic/OSD - blank raster when A1 advanced | RT40 68k 1/2w o/c in RGB o/p base bias cct | 14-09-04 |
| Ferguson | TX805 | no start up | start up res RP44/42/41 sus - usually 68k | 14-09-04 |
| Ferguson | TX805 | No start up or H.T. | CHECK D18 AND ALSO THE PULSE FROM , O.C. PRINT etc. | 14-09-04 |
| Ferguson | TX805 | Picture poor , very dim. | RC23 150k oc or high ( measure out of cct ) . | 14-09-04 |
| Ferguson | TX805 | POOR SOUND , DIST. | CHECK RA10 IS CORRECT ( 680ohm ) NOT 6K8. | 14-09-04 |
| Ferguson | TX805 | Shutting down Int. or Dead. | Ck 15V supply resistors. | 14-09-04 |
| Ferguson | TX805 | Squeal then dead | CP17 100µ 160v s/c - 103v reservoir cap | 14-09-04 |
| Ferguson | TX805 | St/by only | RP41 68k near TP15 hi res - also check RP42, RP44 | 14-09-04 |