| Make | Model | Problem | Solution | Date |
| | | |
| Found: 5614
|
| Aiko | CT20 | Int dead | dry joint R233 | 14-09-04 |
| Aiko | CT20 | Int field - height | FOP tr Q303 2SB546A faulty - used TIP42C in lieu | 14-09-04 |
| Aiwa | C202KER | Field collapse | Fusible link 1500 marked as jumper lead from loptx to reg via D6813 | 14-09-04 |
| Aiwa | CXZR800K | At sw on relay clicks "DEMO" displayed then dead - keeps repeating | Check 2 x 2SK2723 FETs on sound o/p heatsink | 14-09-04 |
| Aiwa | TVC211 | St/by only | Replace EEPROM & R617 - the cause - which goes hi res | 14-09-04 |
| Aiwa | VTV CTV/VCR | Dead | R 519 100k STARTUP CIRCUIT. HT SUPPLY ( 103v ) VIA THIS CIRCUIT. SIMILAR TO ORION VTV. | 14-09-04 |
| Akai | Comp D2 | Dead | D/J on on off switch or On off switch burnt | 14-09-04 |
| Akai | CT-T21N32S | I have an Akai CT-T21N32S which will not fire up, the red LED is illuminated on the front but nothing else happens, I have tested dozens of components but to no avail, the block diagram in the service manual I have is unreadable which is quite upsetting a | cure: replace eeprom IC602 ref
| 23-06-05 |
| Akai | CT1417D | St/by only | C406 | 14-09-04 |
| Akai | CT1417UK | Field collapse | C411 leaky | 14-09-04 |
|
|
| Akai | CT1417UK | FRAME COLLAPSE | C411 LEAKY | 14-09-04 |
| Akai | CT20K2PA | Dark pic - increasing sub brill resulted in field coll | R436 120k o/c | 14-09-04 |
| Akai | CT2107MS (Onwa) | Int off with blob in centre of screen | Check for hairline cracks around chopper tfmr pins | 14-09-04 |
| Akai | CT2115UK | Lack of width & burning smell | R824 100R 2W overheating due to dry joint L824 | 14-09-04 |
| Akai | CT2115UK | St/by only | PCA84C640P micro | 14-09-04 |
| Akai | CT2125 | Comes on with chirping noise & st/by led on then trips out after 1/2 min | C817 100µ 25v | 14-09-04 |
| Akai | CT2125 | Int blank raster with fb lines | OK when con TD203 on txt pcb removed - TZ01 27Mhz Xtal | 14-09-04 |
| Akai | CT2137 | Field scan only I" | No 33v via R442 - 5R16 8k2 o/c | 14-09-04 |
| Akai | CT2137UKT | No sound except hiss - ok through scart | when a 6Mhz resonator was fitted in vacant place 30F1 sound ok | 14-09-04 |
| Akai | CT2137UKT | Vision buzz | Remove digital transistor 9tr9 | 14-09-04 |
| Akai | CT2142VNT | Poor pic with fbck lines and curious col | IC301 pin 12 supply only 7v5 (9v1). R424 (0R68) hi res | 14-09-04 |
| Akai | CT2159 Onwa | Field faulty - int lines at top etc | C417 220mfd 16v, C423 2200mfd 25v, C435 470mfd 16v | 14-09-04 |
| Akai | CT2159UT Onwa | No start up | C910 & C912 47µ | 14-09-04 |
| Akai | CT2159VT | Dead | Sw mode tr overheats - replace D901, C405, C910, C912 & C431 | 14-09-04 |
| Akai | CT215UK | Trips off with chirp & no st/by | C817 100µ o/c | 14-09-04 |
| Akai | CT2179N-UK | Line osc too fast | C416 220pf 1kv dry joint, R412 10k ?w o/c | 14-09-04 |
| Akai | CT2179NUK | Whistles for 1sec then dead | C807 47uF 25v | 14-09-04 |
| Akai | CT2179UK | Int blanking pic | RIC01 SPH113 chip faulty (blanking sig o/p at pin 25) | 14-09-04 |
| Akai | CT2185 | Reverts to st/by aft few secs from sw on | Pin 19 of micro low - R748 100k pull up res faulty | 14-09-04 |
| Akai | CT2185-10 | St/by only | dry joints psu | 14-09-04 |