| Make | Model | Problem | Solution | Date |
| | | |
| Found: 113
|
| Akai | CT1417D | St/by only | C406 | 14-09-04 |
| Akai | CT1417UK | Field collapse | C411 leaky | 14-09-04 |
| Akai | CT1417UK | FRAME COLLAPSE | C411 LEAKY | 14-09-04 |
| Goodmans | Compact 10 | Dead | Field chip AN5512 | 14-09-04 |
| Goodmans | COMPACT 110 | Dead | CHECK REG , AND FIELD CHIP AN5512 Pt No. CPC*HN5652AN5512 | 14-09-04 |
| Goodmans | Compact 110 | Dead | High HT can cause havoc rendering set beyond repair - signs are bulging elects in fop stage | 14-09-04 |
| Goodmans | Compact 110 | Dead | Remove black glue, check 180k start up resistors & 47µ caps in psu | 14-09-04 |
| Goodmans | Compact 110 | Dead | Check CP22 & 30 100µ & RP04 & 05 180k. QP01 2SA1012 - use BD224C in lieu. ZP06 6v8 zener & RV01 4R7 & ICV1 TDA3653 | 14-09-04 |
| Goodmans | Compact 110 | Dead - no psu o/p | DP09 s/c, RP20 burnt up | 14-09-04 |
| Goodmans | Compact 110 | Dead - no psu operation | R5 180k o/c | 14-09-04 |
|
|
| Goodmans | Compact 110 | Dead - psu blows up | Onwa kit available | 14-09-04 |
| Goodmans | Compact 110 | Dead after ran on 24v instead of 12v | QPD1 2SB826 reg s/c, when replaced field collapse - TDA3653B fop chip & feed res burnt - used 4R7 1/4w & replace HT pot for int pic size with lines | 14-09-04 |
| Goodmans | Compact 110 | Dead -went off with a flash | burn up on pcb between CP10 & link adjacent to RP06 - RP06 39R 7w o/c, dry joints RP09 & remove black glue | 14-09-04 |
| Goodmans | Compact 110 | Field - lack of height with bottom compressed | RP05 8k2 3w metal film o/c | 14-09-04 |
| Goodmans | Compact 110 | Int field collapse with short, bright hor line | Dry joint A1/focus earth pin on LOPTx | 14-09-04 |
| Goodmans | Compact 110 | Line collapse | CH01 4µ7 50v bipolar o/c | 14-09-04 |
| Goodmans | Compact 110 | Line collapse & no sound | Dry joint LH01 | 14-09-04 |
| Goodmans | Compact 110 | St/by only | ZP06 8v2 zener (set had been connected to 12v wrong way round) - Mk 1 version | 14-09-04 |
| Goodmans | Compact 110/2 | No sound/pic with LED lit & 12v present | DH04 s/c pt no ACTI13051025 | 14-09-04 |
| Goodmans | Compact100 | hum bar when heated | 1N5402 rect diode o/c | 14-09-04 |
| Goodmans | Compact110 | Line drive int | CH03 10mfd 25v | 14-09-04 |
| Goodmans | Compact110 | Whistling/whining in st/by | Reg 10.8v not dropped to 0v - Micro pin30 not shutting off reg (should be 12v in st/by) - micro faulty | 14-09-04 |
| Goodmans | Compact110 | Won't go into st/by | CR02 0.1mfd o/c | 14-09-04 |
| Goodmans | Compact110/2 | Line collapse | Dry joints LH01 & CH01 in line coil coupling | 14-09-04 |
| Harwood | CT14 | Drifts off tune | Check D9 - 16 and clean tuning pots/panel | 14-09-04 |
| Harwood | CT14 | No pic - when A1 increased field collaps noticed | TDA3651 brought back partial field scan but not until TDA3651 was field fully restored | 14-09-04 |
| Harwood | CT14 | SOUND BUT NO PICTURE - FIELD COLLAPSE | REPLACE TDA3651 IF FIELD NOW LOW , CHECK PIN 2 TDA4503 DRIVE SHOULD BE 2v Pk-Pk IF NOT REPLACE TDA4503 | 14-09-04 |
| Hinari | CT11 | Tripping | Works ok with Q117 on main pcb dis'd - purpose of this tr? | 14-09-04 |
| Hinari | CT11 | Tripping. | Remove base of Q17 the set will work without it! | 14-09-04 |
| Hinari | CT11 | TRIPS IF FRONT PANEL DISCONNECTED SET RUNS | REMOVE BASE Q17 !! | 14-09-04 |