| Make | Model | Problem | Solution | Date |
| | | |
| Found: 185
|
| GEC | C1402H CVC801 | Startup - dead. | IC700 ( 7812 ) 12v reg , T873 , IC870 ( TDA2140 ) check by change | 14-09-04 |
| ITT | 3493 CVC1200 | No sound - colour or remote. | IC SAA1251 Remote decoder IC. | 14-09-04 |
|
|
| ITT | 3493 CVC1200 | No startup or light on in standby but still o | Check for shorted out relay pins , Tx 4511 3109 faulty. | 14-09-04 |
| ITT | 3493 CVC1200 | Remote control inoperative | IC SAA1251 | 14-09-04 |
| ITT | 3732 CVC825P | Frame - Hight & width low. | 145v rail down - R651 ( 120k ) high. | 14-09-04 |
| ITT | 3732 CVC825P | Width & hight low. | 145v rail down - R651 ( 120k ) high. | 14-09-04 |
| ITT | 80-90 deg CVC823 | No results - PSU heavily loaded. | C1021 ( 270pf ) | 14-09-04 |
| ITT | 80-90 deg CVC823 | Slight hum bar & touchy tuning. | Cracked print at 90v supply res capacitor C516 ( 10uf ) | 14-09-04 |
| ITT | 80-90 deg CVC824 | Screen flashing white - PSU trips momentarily | CRT. | 14-09-04 |
| ITT | CB9604 CVC40 | Flyback lines - A1 control not working. | R46/48 ( 820k ) on main PCB o/c. | 14-09-04 |
| ITT | CB9604 CVC40 | No frame. | T7 ( BC527 ) on CMF40. | 14-09-04 |
| ITT | CD652 CVC25/3 | Channels - stuck on channel 1. | C5 leaky. | 14-09-04 |
| ITT | CP332 CVC40 | Dead - Intermittent shut down. | BU208A loose bolt. | 14-09-04 |
| ITT | CP332 CVC40 | Frame collapse. | R2003 ( 1k ) field hold control o/c. | 14-09-04 |
| ITT | CS0614 CVC823P | No sound or picture - stuck on channel 1. | IC on front unit SAA1251. | 14-09-04 |
| ITT | CS0624/1/T CVC824 | No sound or picture - seems like tripler. | D513 ( RGP30M ) behind angled heat sink R/H side PCB. | 14-09-04 |
| ITT | CT1600 CVC824 | 122v rail going low. | Change T617 ( BC238 ) | 14-09-04 |
| ITT | CT1600 CVC824 | Bars on saturated colours. | C312 ( 2.2uf ) o/c. | 14-09-04 |
| ITT | CT1600 CVC824 | Dark lines on colour. | C312 ( 2.2uf ) o/c. | 14-09-04 |
| ITT | CT2500 CVC1150 | Dead. | TR716 , 715 , D685 s/c , caused by TR731 ( BC328-52 ) s/c , D714 | 14-09-04 |
| ITT | CT2512 CVC1200 | No EHT. | TR741 ( BC328 ) right hand side of chassis. | 14-09-04 |
| ITT | CT2512 CVC1200 | No go Standby LED on. | R744 o/c right hand side of chassis. | 14-09-04 |
|
|
| ITT | CT2600 CVC1210 | Dead - with ticking noise. | BU208A , T562 ( BD135 ) , R503 ( 100ohm ) if LOPTX hot change it. | 14-09-04 |
| ITT | CT2712 CVC1200 | White raster with flyback lines. | Diodes by BU208 go s/c , a Ristor burnt up ( use BY133 ) | 14-09-04 |
| ITT | CT2712 CVC1203 | Dead. | MR diode s/c , may have taken tripler. | 14-09-04 |
| ITT | CT2712 CVC1203 | No Frame - resistor R522 burnt up. | R522 is a 0.47R , D523 ( BA158 ) , TBA2653A | 14-09-04 |
| ITT | CT2712 CVC1203 | No tuner voltage. | R522 is a 0.47R , D523 ( BA158 ) , TBA2653A | 14-09-04 |
| ITT | CT600 CVC823 | Line pulling - two or three times a second. | VCR switch on PB unit. | 14-09-04 |
| ITT | CTV1204 CVC1204 | Dead. | Blows BU508 at switch on , check C701 for s/c. | 14-09-04 |
| ITT | CVC100 | dead with whistling only from psu | No 115v HT - 120v zener D658 leaky | 14-09-04 |